blob: 9438fffaf0ba36dcb048ff6538d8a88c563fe5d5 [file] [log] [blame]
# SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
%YAML 1.2
---
$id: http://devicetree.org/schemas/iio/magnetometer/yamaha,yas530.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#
title: Yamaha YAS530 family of magnetometer sensors
maintainers:
- Linus Walleij <linus.walleij@linaro.org>
description:
The Yamaha YAS530 magnetometers is a line of 3-axis magnetometers
first introduced by Yamaha in 2009 with the YAS530. They are successors
of Yamaha's first magnetometer YAS529. Over the years this magnetometer
has been miniaturized and appeared in a number of different variants.
properties:
$nodename:
pattern: '^magnetometer@[0-9a-f]+$'
compatible:
items:
- enum:
- yamaha,yas530
- yamaha,yas532
- yamaha,yas533
- yamaha,yas535
- yamaha,yas536
- yamaha,yas537
- yamaha,yas539
reg:
maxItems: 1
reset-gpios:
maxItems: 1
description: The YAS530 sensor has a RSTN pin used to reset
the logic inside the sensor. This GPIO line should connect
to that pin and be marked as GPIO_ACTIVE_LOW.
interrupts:
maxItems: 1
description: Interrupt for INT pin for interrupt generation.
The polarity, whether the interrupt is active on the rising
or the falling edge, is software-configurable in the hardware.
vdd-supply:
description: An optional regulator providing core power supply
on the VDD pin, typically 1.8 V or 3.0 V.
iovdd-supply:
description: An optional regulator providing I/O power supply
for the I2C interface on the IOVDD pin, typically 1.8 V.
mount-matrix:
description: An optional 3x3 mounting rotation matrix.
allOf:
- if:
not:
properties:
compatible:
items:
const: yamaha,yas530
then:
properties:
reset-gpios: false
- if:
properties:
compatible:
items:
const: yamaha,yas539
then:
properties:
interrupts: false
required:
- compatible
- reg
additionalProperties: false
examples:
- |
#include <dt-bindings/interrupt-controller/irq.h>
#include <dt-bindings/gpio/gpio.h>
i2c-0 {
#address-cells = <1>;
#size-cells = <0>;
magnetometer@2e {
compatible = "yamaha,yas530";
reg = <0x2e>;
vdd-supply = <&ldo1_reg>;
iovdd-supply = <&ldo2_reg>;
reset-gpios = <&gpio6 12 GPIO_ACTIVE_LOW>;
interrupts = <13 IRQ_TYPE_EDGE_RISING>;
};
};
i2c-1 {
#address-cells = <1>;
#size-cells = <0>;
magnetometer@2e {
compatible = "yamaha,yas539";
reg = <0x2e>;
vdd-supply = <&ldo1_reg>;
};
};