blob: 4e713f4cdb2f9cfc23a206918937c964b0a70113 [file] [log] [blame]
Kernel driver i2c-ocores
Supported adapters:
* OpenCores.org I2C controller by Richard Herveille (see datasheet link)
https://opencores.org/project/i2c/overview
Author: Peter Korsgaard <jacmet@sunsite.dk>
Description
-----------
i2c-ocores is an i2c bus driver for the OpenCores.org I2C controller
IP core by Richard Herveille.
Usage
-----
i2c-ocores uses the platform bus, so you need to provide a struct
platform_device with the base address and interrupt number. The
dev.platform_data of the device should also point to a struct
ocores_i2c_platform_data (see linux/platform_data/i2c-ocores.h) describing the
distance between registers and the input clock speed.
There is also a possibility to attach a list of i2c_board_info which
the i2c-ocores driver will add to the bus upon creation.
E.G. something like:
static struct resource ocores_resources[] = {
[0] = {
.start = MYI2C_BASEADDR,
.end = MYI2C_BASEADDR + 8,
.flags = IORESOURCE_MEM,
},
[1] = {
.start = MYI2C_IRQ,
.end = MYI2C_IRQ,
.flags = IORESOURCE_IRQ,
},
};
/* optional board info */
struct i2c_board_info ocores_i2c_board_info[] = {
{
I2C_BOARD_INFO("tsc2003", 0x48),
.platform_data = &tsc2003_platform_data,
.irq = TSC_IRQ
},
{
I2C_BOARD_INFO("adv7180", 0x42 >> 1),
.irq = ADV_IRQ
}
};
static struct ocores_i2c_platform_data myi2c_data = {
.regstep = 2, /* two bytes between registers */
.clock_khz = 50000, /* input clock of 50MHz */
.devices = ocores_i2c_board_info, /* optional table of devices */
.num_devices = ARRAY_SIZE(ocores_i2c_board_info), /* table size */
};
static struct platform_device myi2c = {
.name = "ocores-i2c",
.dev = {
.platform_data = &myi2c_data,
},
.num_resources = ARRAY_SIZE(ocores_resources),
.resource = ocores_resources,
};