| # SPDX-License-Identifier: GPL-2.0-only | |
| # | |
| # Davicom device configuration | |
| # | |
| config NET_VENDOR_DAVICOM | |
| bool "Davicom devices" | |
| default y | |
| help | |
| If you have a network (Ethernet) card belonging to this class, say Y. | |
| Note that the answer to this question doesn't directly affect the | |
| kernel: saying N will just cause the configurator to skip all | |
| the questions about Davicom devices. If you say Y, you will be asked | |
| for your specific card in the following selections. | |
| if NET_VENDOR_DAVICOM | |
| config DM9000 | |
| tristate "DM9000 support" | |
| depends on ARM || MIPS || COLDFIRE || NIOS2 || COMPILE_TEST | |
| select CRC32 | |
| select MII | |
| help | |
| Support for DM9000 chipset. | |
| To compile this driver as a module, choose M here. The module | |
| will be called dm9000. | |
| config DM9000_FORCE_SIMPLE_PHY_POLL | |
| bool "Force simple NSR based PHY polling" | |
| depends on DM9000 | |
| help | |
| This configuration forces the DM9000 to use the NSR's LinkStatus | |
| bit to determine if the link is up or down instead of the more | |
| costly MII PHY reads. Note, this will not work if the chip is | |
| operating with an external PHY. | |
| config DM9051 | |
| tristate "DM9051 SPI support" | |
| depends on SPI | |
| select CRC32 | |
| select MDIO | |
| select PHYLIB | |
| select REGMAP_SPI | |
| help | |
| Support for DM9051 SPI chipset. | |
| To compile this driver as a module, choose M here. The module | |
| will be called dm9051. | |
| The SPI mode for the host's SPI master to access DM9051 is mode | |
| 0 on the SPI bus. | |
| endif # NET_VENDOR_DAVICOM |