| # | |
| # Asix network device configuration | |
| # | |
| config NET_VENDOR_ASIX | |
| bool "Asix devices" | |
| default y | |
| help | |
| If you have a network (Ethernet, non-USB, not NE2000 compatible) | |
| interface based on a chip from ASIX, say Y. | |
| if NET_VENDOR_ASIX | |
| config SPI_AX88796C | |
| tristate "Asix AX88796C-SPI support" | |
| select PHYLIB | |
| depends on SPI | |
| depends on GPIOLIB | |
| help | |
| Say Y here if you intend to use ASIX AX88796C attached in SPI mode. | |
| config SPI_AX88796C_COMPRESSION | |
| bool "SPI transfer compression" | |
| default n | |
| depends on SPI_AX88796C | |
| help | |
| Say Y here to enable SPI transfer compression. It saves up | |
| to 24 dummy cycles during each transfer which may noticeably | |
| speed up short transfers. This sets the default value that is | |
| inherited by network interfaces during probe. It can be | |
| changed at run time via spi-compression ethtool tunable. | |
| If unsure say N. | |
| endif # NET_VENDOR_ASIX |