| // SPDX-License-Identifier: GPL-2.0 | |
| /* | |
| * Copyright (C) 2011 - 2012 Cavium, Inc. | |
| */ | |
| #include <linux/module.h> | |
| #include <linux/phy.h> | |
| #include <linux/of.h> | |
| #define PHY_ID_BCM8706 0x0143bdc1 | |
| #define PHY_ID_BCM8727 0x0143bff0 | |
| #define BCM87XX_PMD_RX_SIGNAL_DETECT 0x000a | |
| #define BCM87XX_10GBASER_PCS_STATUS 0x0020 | |
| #define BCM87XX_XGXS_LANE_STATUS 0x0018 | |
| #define BCM87XX_LASI_CONTROL 0x9002 | |
| #define BCM87XX_LASI_STATUS 0x9005 | |
| #if IS_ENABLED(CONFIG_OF_MDIO) | |
| /* Set and/or override some configuration registers based on the | |
| * broadcom,c45-reg-init property stored in the of_node for the phydev. | |
| * | |
| * broadcom,c45-reg-init = <devid reg mask value>,...; | |
| * | |
| * There may be one or more sets of <devid reg mask value>: | |
| * | |
| * devid: which sub-device to use. | |
| * reg: the register. | |
| * mask: if non-zero, ANDed with existing register value. | |
| * value: ORed with the masked value and written to the regiser. | |
| * | |
| */ | |
| static int bcm87xx_of_reg_init(struct phy_device *phydev) | |
| { | |
| const __be32 *paddr; | |
| const __be32 *paddr_end; | |
| int len, ret; | |
| if (!phydev->mdio.dev.of_node) | |
| return 0; | |
| paddr = of_get_property(phydev->mdio.dev.of_node, | |
| "broadcom,c45-reg-init", &len); | |
| if (!paddr) | |
| return 0; | |
| paddr_end = paddr + (len /= sizeof(*paddr)); | |
| ret = 0; | |
| while (paddr + 3 < paddr_end) { | |
| u16 devid = be32_to_cpup(paddr++); | |
| u16 reg = be32_to_cpup(paddr++); | |
| u16 mask = be32_to_cpup(paddr++); | |
| u16 val_bits = be32_to_cpup(paddr++); | |
| int val = 0; | |
| if (mask) { | |
| val = phy_read_mmd(phydev, devid, reg); | |
| if (val < 0) { | |
| ret = val; | |
| goto err; | |
| } | |
| val &= mask; | |
| } | |
| val |= val_bits; | |
| ret = phy_write_mmd(phydev, devid, reg, val); | |
| if (ret < 0) | |
| goto err; | |
| } | |
| err: | |
| return ret; | |
| } | |
| #else | |
| static int bcm87xx_of_reg_init(struct phy_device *phydev) | |
| { | |
| return 0; | |
| } | |
| #endif /* CONFIG_OF_MDIO */ | |
| static int bcm87xx_get_features(struct phy_device *phydev) | |
| { | |
| linkmode_set_bit(ETHTOOL_LINK_MODE_10000baseR_FEC_BIT, | |
| phydev->supported); | |
| return 0; | |
| } | |
| static int bcm87xx_config_init(struct phy_device *phydev) | |
| { | |
| return bcm87xx_of_reg_init(phydev); | |
| } | |
| static int bcm87xx_config_aneg(struct phy_device *phydev) | |
| { | |
| return -EINVAL; | |
| } | |
| static int bcm87xx_read_status(struct phy_device *phydev) | |
| { | |
| int rx_signal_detect; | |
| int pcs_status; | |
| int xgxs_lane_status; | |
| rx_signal_detect = phy_read_mmd(phydev, MDIO_MMD_PMAPMD, | |
| BCM87XX_PMD_RX_SIGNAL_DETECT); | |
| if (rx_signal_detect < 0) | |
| return rx_signal_detect; | |
| if ((rx_signal_detect & 1) == 0) | |
| goto no_link; | |
| pcs_status = phy_read_mmd(phydev, MDIO_MMD_PCS, | |
| BCM87XX_10GBASER_PCS_STATUS); | |
| if (pcs_status < 0) | |
| return pcs_status; | |
| if ((pcs_status & 1) == 0) | |
| goto no_link; | |
| xgxs_lane_status = phy_read_mmd(phydev, MDIO_MMD_PHYXS, | |
| BCM87XX_XGXS_LANE_STATUS); | |
| if (xgxs_lane_status < 0) | |
| return xgxs_lane_status; | |
| if ((xgxs_lane_status & 0x1000) == 0) | |
| goto no_link; | |
| phydev->speed = 10000; | |
| phydev->link = 1; | |
| phydev->duplex = 1; | |
| return 0; | |
| no_link: | |
| phydev->link = 0; | |
| return 0; | |
| } | |
| static int bcm87xx_config_intr(struct phy_device *phydev) | |
| { | |
| int reg, err; | |
| reg = phy_read_mmd(phydev, MDIO_MMD_PCS, BCM87XX_LASI_CONTROL); | |
| if (reg < 0) | |
| return reg; | |
| if (phydev->interrupts == PHY_INTERRUPT_ENABLED) { | |
| err = phy_read_mmd(phydev, MDIO_MMD_PCS, BCM87XX_LASI_STATUS); | |
| if (err) | |
| return err; | |
| reg |= 1; | |
| err = phy_write_mmd(phydev, MDIO_MMD_PCS, | |
| BCM87XX_LASI_CONTROL, reg); | |
| } else { | |
| reg &= ~1; | |
| err = phy_write_mmd(phydev, MDIO_MMD_PCS, | |
| BCM87XX_LASI_CONTROL, reg); | |
| if (err) | |
| return err; | |
| err = phy_read_mmd(phydev, MDIO_MMD_PCS, BCM87XX_LASI_STATUS); | |
| } | |
| return err; | |
| } | |
| static irqreturn_t bcm87xx_handle_interrupt(struct phy_device *phydev) | |
| { | |
| int irq_status; | |
| irq_status = phy_read(phydev, BCM87XX_LASI_STATUS); | |
| if (irq_status < 0) { | |
| phy_error(phydev); | |
| return IRQ_NONE; | |
| } | |
| if (irq_status == 0) | |
| return IRQ_NONE; | |
| phy_trigger_machine(phydev); | |
| return IRQ_HANDLED; | |
| } | |
| static int bcm87xx_match_phy_device(struct phy_device *phydev, | |
| const struct phy_driver *phydrv) | |
| { | |
| return phydev->c45_ids.device_ids[4] == phydrv->phy_id; | |
| } | |
| static struct phy_driver bcm87xx_driver[] = { | |
| { | |
| .phy_id = PHY_ID_BCM8706, | |
| .phy_id_mask = 0xffffffff, | |
| .name = "Broadcom BCM8706", | |
| .get_features = bcm87xx_get_features, | |
| .config_init = bcm87xx_config_init, | |
| .config_aneg = bcm87xx_config_aneg, | |
| .read_status = bcm87xx_read_status, | |
| .config_intr = bcm87xx_config_intr, | |
| .handle_interrupt = bcm87xx_handle_interrupt, | |
| .match_phy_device = bcm87xx_match_phy_device, | |
| }, { | |
| .phy_id = PHY_ID_BCM8727, | |
| .phy_id_mask = 0xffffffff, | |
| .name = "Broadcom BCM8727", | |
| .get_features = bcm87xx_get_features, | |
| .config_init = bcm87xx_config_init, | |
| .config_aneg = bcm87xx_config_aneg, | |
| .read_status = bcm87xx_read_status, | |
| .config_intr = bcm87xx_config_intr, | |
| .handle_interrupt = bcm87xx_handle_interrupt, | |
| .match_phy_device = bcm87xx_match_phy_device, | |
| } }; | |
| module_phy_driver(bcm87xx_driver); | |
| MODULE_LICENSE("GPL v2"); | |
| MODULE_DESCRIPTION("Broadcom BCM87xx PHY driver"); |