| // SPDX-License-Identifier: GPL-2.0-only |
| |
| #include <linux/array_size.h> |
| #include <linux/delay.h> |
| #include <linux/err.h> |
| #include <linux/gpio/consumer.h> |
| #include <linux/mod_devicetable.h> |
| #include <linux/module.h> |
| #include <linux/property.h> |
| #include <linux/regulator/consumer.h> |
| |
| #include <video/mipi_display.h> |
| |
| #include <drm/drm_mipi_dsi.h> |
| #include <drm/drm_modes.h> |
| #include <drm/drm_panel.h> |
| #include <drm/drm_probe_helper.h> |
| |
| static const struct regulator_bulk_data lg_ld070wx3_supplies[] = { |
| { .supply = "vdd" }, { .supply = "vcc" }, |
| }; |
| |
| struct lg_ld070wx3 { |
| struct drm_panel panel; |
| struct mipi_dsi_device *dsi; |
| |
| struct regulator_bulk_data *supplies; |
| }; |
| |
| static inline struct lg_ld070wx3 *to_lg_ld070wx3(struct drm_panel *panel) |
| { |
| return container_of(panel, struct lg_ld070wx3, panel); |
| } |
| |
| static int lg_ld070wx3_prepare(struct drm_panel *panel) |
| { |
| struct lg_ld070wx3 *priv = to_lg_ld070wx3(panel); |
| struct mipi_dsi_multi_context ctx = { .dsi = priv->dsi }; |
| struct device *dev = panel->dev; |
| int ret; |
| |
| ret = regulator_bulk_enable(ARRAY_SIZE(lg_ld070wx3_supplies), priv->supplies); |
| if (ret < 0) { |
| dev_err(dev, "failed to enable power supplies: %d\n", ret); |
| return ret; |
| } |
| |
| /* |
| * According to spec delay between enabling supply is 0, |
| * for regulators to reach required voltage ~5ms needed. |
| * MIPI interface signal for setup requires additional |
| * 110ms which in total results in 115ms. |
| */ |
| mdelay(115); |
| |
| mipi_dsi_dcs_soft_reset_multi(&ctx); |
| mipi_dsi_msleep(&ctx, 20); |
| |
| /* Differential input impedance selection */ |
| mipi_dsi_dcs_write_seq_multi(&ctx, 0xae, 0x0b); |
| |
| /* Enter test mode 1 and 2*/ |
| mipi_dsi_dcs_write_seq_multi(&ctx, 0xee, 0xea); |
| mipi_dsi_dcs_write_seq_multi(&ctx, 0xef, 0x5f); |
| |
| /* Increased MIPI CLK driving ability */ |
| mipi_dsi_dcs_write_seq_multi(&ctx, 0xf2, 0x68); |
| |
| /* Exit test mode 1 and 2 */ |
| mipi_dsi_dcs_write_seq_multi(&ctx, 0xee, 0x00); |
| mipi_dsi_dcs_write_seq_multi(&ctx, 0xef, 0x00); |
| |
| return ctx.accum_err; |
| } |
| |
| static int lg_ld070wx3_unprepare(struct drm_panel *panel) |
| { |
| struct lg_ld070wx3 *priv = to_lg_ld070wx3(panel); |
| struct mipi_dsi_multi_context ctx = { .dsi = priv->dsi }; |
| |
| mipi_dsi_dcs_enter_sleep_mode_multi(&ctx); |
| |
| msleep(50); |
| |
| regulator_bulk_disable(ARRAY_SIZE(lg_ld070wx3_supplies), priv->supplies); |
| |
| /* power supply must be off for at least 1s after panel disable */ |
| msleep(1000); |
| |
| return 0; |
| } |
| |
| static const struct drm_display_mode lg_ld070wx3_mode = { |
| .clock = (800 + 32 + 48 + 8) * (1280 + 5 + 3 + 1) * 60 / 1000, |
| .hdisplay = 800, |
| .hsync_start = 800 + 32, |
| .hsync_end = 800 + 32 + 48, |
| .htotal = 800 + 32 + 48 + 8, |
| .vdisplay = 1280, |
| .vsync_start = 1280 + 5, |
| .vsync_end = 1280 + 5 + 3, |
| .vtotal = 1280 + 5 + 3 + 1, |
| .width_mm = 94, |
| .height_mm = 151, |
| .type = DRM_MODE_TYPE_DRIVER | DRM_MODE_TYPE_PREFERRED, |
| }; |
| |
| static int lg_ld070wx3_get_modes(struct drm_panel *panel, |
| struct drm_connector *connector) |
| { |
| return drm_connector_helper_get_modes_fixed(connector, &lg_ld070wx3_mode); |
| } |
| |
| static const struct drm_panel_funcs lg_ld070wx3_panel_funcs = { |
| .prepare = lg_ld070wx3_prepare, |
| .unprepare = lg_ld070wx3_unprepare, |
| .get_modes = lg_ld070wx3_get_modes, |
| }; |
| |
| static int lg_ld070wx3_probe(struct mipi_dsi_device *dsi) |
| { |
| struct device *dev = &dsi->dev; |
| struct lg_ld070wx3 *priv; |
| int ret; |
| |
| priv = devm_drm_panel_alloc(dev, struct lg_ld070wx3, panel, |
| &lg_ld070wx3_panel_funcs, |
| DRM_MODE_CONNECTOR_DSI); |
| if (IS_ERR(priv)) |
| return PTR_ERR(priv); |
| |
| ret = devm_regulator_bulk_get_const(dev, ARRAY_SIZE(lg_ld070wx3_supplies), |
| lg_ld070wx3_supplies, &priv->supplies); |
| if (ret < 0) |
| return dev_err_probe(dev, ret, "failed to get supplies\n"); |
| |
| priv->dsi = dsi; |
| mipi_dsi_set_drvdata(dsi, priv); |
| |
| dsi->lanes = 4; |
| dsi->format = MIPI_DSI_FMT_RGB888; |
| dsi->mode_flags = MIPI_DSI_MODE_VIDEO | MIPI_DSI_MODE_LPM; |
| |
| ret = drm_panel_of_backlight(&priv->panel); |
| if (ret < 0) |
| return dev_err_probe(dev, ret, "failed to get backlight\n"); |
| |
| drm_panel_add(&priv->panel); |
| |
| ret = devm_mipi_dsi_attach(dev, dsi); |
| if (ret < 0) { |
| drm_panel_remove(&priv->panel); |
| return dev_err_probe(dev, ret, "failed to attach to DSI host\n"); |
| } |
| |
| return 0; |
| } |
| |
| static void lg_ld070wx3_remove(struct mipi_dsi_device *dsi) |
| { |
| struct lg_ld070wx3 *priv = mipi_dsi_get_drvdata(dsi); |
| |
| drm_panel_remove(&priv->panel); |
| } |
| |
| static const struct of_device_id lg_ld070wx3_of_match[] = { |
| { .compatible = "lg,ld070wx3-sl01" }, |
| { /* sentinel */ } |
| }; |
| MODULE_DEVICE_TABLE(of, lg_ld070wx3_of_match); |
| |
| static struct mipi_dsi_driver lg_ld070wx3_driver = { |
| .driver = { |
| .name = "panel-lg-ld070wx3", |
| .of_match_table = lg_ld070wx3_of_match, |
| }, |
| .probe = lg_ld070wx3_probe, |
| .remove = lg_ld070wx3_remove, |
| }; |
| module_mipi_dsi_driver(lg_ld070wx3_driver); |
| |
| MODULE_AUTHOR("Svyatoslav Ryhel <clamor95@gmail.com>"); |
| MODULE_DESCRIPTION("LG LD070WX3-SL01 DSI panel driver"); |
| MODULE_LICENSE("GPL"); |