| // SPDX-License-Identifier: BSD-3-Clause |
| /* |
| * Copyright (c) 2025, Luca Weiss <luca.weiss@fairphone.com> |
| */ |
| |
| #include <dt-bindings/interrupt-controller/irq.h> |
| #include <dt-bindings/spmi/spmi.h> |
| |
| / { |
| thermal-zones { |
| pm7550_thermal: pm7550-thermal { |
| polling-delay-passive = <100>; |
| |
| thermal-sensors = <&pm7550_temp_alarm>; |
| |
| trips { |
| trip0 { |
| temperature = <95000>; |
| hysteresis = <0>; |
| type = "passive"; |
| }; |
| |
| trip1 { |
| /* |
| * Current Linux driver currently only supports up to |
| * 125°C, should be updated to 145°C once available. |
| */ |
| temperature = <125000>; |
| hysteresis = <0>; |
| type = "critical"; |
| }; |
| }; |
| }; |
| }; |
| }; |
| |
| &spmi_bus { |
| pm7550: pmic@1 { |
| compatible = "qcom,pm7550", "qcom,spmi-pmic"; |
| reg = <0x1 SPMI_USID>; |
| #address-cells = <1>; |
| #size-cells = <0>; |
| |
| pm7550_temp_alarm: temp-alarm@a00 { |
| compatible = "qcom,spmi-temp-alarm"; |
| reg = <0xa00>; |
| interrupts = <0x1 0xa 0x0 IRQ_TYPE_EDGE_BOTH>; |
| #thermal-sensor-cells = <0>; |
| }; |
| |
| pm7550_gpios: gpio@8800 { |
| compatible = "qcom,pm7550-gpio", "qcom,spmi-gpio"; |
| reg = <0x8800>; |
| gpio-controller; |
| gpio-ranges = <&pm7550_gpios 0 0 12>; |
| #gpio-cells = <2>; |
| interrupt-controller; |
| #interrupt-cells = <2>; |
| }; |
| |
| pm7550_flash: led-controller@ee00 { |
| compatible = "qcom,pm7550-flash-led", "qcom,spmi-flash-led"; |
| reg = <0xee00>; |
| status = "disabled"; |
| }; |
| }; |
| }; |
