| # SPDX-License-Identifier: GPL-2.0 | |
| menuconfig ARCH_DAVINCI | |
| bool "TI DaVinci" | |
| depends on ARCH_MULTI_V5 | |
| depends on CPU_LITTLE_ENDIAN | |
| select ARCH_DAVINCI_DA850 | |
| select CPU_ARM926T | |
| select DAVINCI_TIMER | |
| select ZONE_DMA | |
| select PM_GENERIC_DOMAINS if PM | |
| select PM_GENERIC_DOMAINS_OF if PM && OF | |
| select REGMAP_MMIO | |
| select RESET_CONTROLLER | |
| select PINCTRL | |
| select PINCTRL_SINGLE | |
| if ARCH_DAVINCI | |
| comment "DaVinci Core Type" | |
| config ARCH_DAVINCI_DA850 | |
| bool "DA850/OMAP-L138/AM18x based system" | |
| select ARCH_DAVINCI_DA8XX | |
| select DAVINCI_CP_INTC | |
| config ARCH_DAVINCI_DA8XX | |
| bool | |
| config DAVINCI_MUX | |
| bool "DAVINCI multiplexing support" | |
| depends on ARCH_DAVINCI | |
| default y | |
| help | |
| Pin multiplexing support for DAVINCI boards. If your bootloader | |
| sets the multiplexing correctly, say N. Otherwise, or if unsure, | |
| say Y. | |
| config DAVINCI_MUX_DEBUG | |
| bool "Multiplexing debug output" | |
| depends on DAVINCI_MUX | |
| help | |
| Makes the multiplexing functions print out a lot of debug info. | |
| This is useful if you want to find out the correct values of the | |
| multiplexing registers. | |
| config DAVINCI_MUX_WARNINGS | |
| bool "Warn about pins the bootloader didn't set up" | |
| depends on DAVINCI_MUX | |
| help | |
| Choose Y here to warn whenever driver initialization logic needs | |
| to change the pin multiplexing setup. When there are no warnings | |
| printed, it's safe to deselect DAVINCI_MUX for your product. | |
| endif |