| # SPDX-License-Identifier: GPL-2.0 | |
| %YAML 1.2 | |
| --- | |
| $id: http://devicetree.org/schemas/mmc/mmc-pwrseq-emmc.yaml# | |
| $schema: http://devicetree.org/meta-schemas/core.yaml# | |
| title: Simple eMMC hardware reset provider | |
| maintainers: | |
| - Ulf Hansson <ulf.hansson@linaro.org> | |
| description: | |
| The purpose of this driver is to perform standard eMMC hw reset | |
| procedure, as described by Jedec 4.4 specification. This procedure is | |
| performed just after MMC core enabled power to the given mmc host (to | |
| fix possible issues if bootloader has left eMMC card in initialized or | |
| unknown state), and before performing complete system reboot (also in | |
| case of emergency reboot call). The latter is needed on boards, which | |
| doesn't have hardware reset logic connected to emmc card and (limited or | |
| broken) ROM bootloaders are unable to read second stage from the emmc | |
| card if the card is left in unknown or already initialized state. | |
| properties: | |
| compatible: | |
| const: mmc-pwrseq-emmc | |
| reset-gpios: | |
| minItems: 1 | |
| description: | |
| contains a GPIO specifier. The reset GPIO is asserted | |
| and then deasserted to perform eMMC card reset. To perform | |
| reset procedure as described in Jedec 4.4 specification, the | |
| gpio line should be defined as GPIO_ACTIVE_LOW. | |
| required: | |
| - compatible | |
| - reset-gpios | |
| additionalProperties: false | |
| examples: | |
| - | | |
| #include <dt-bindings/gpio/gpio.h> | |
| pwrseq { | |
| compatible = "mmc-pwrseq-emmc"; | |
| reset-gpios = <&gpio1 12 GPIO_ACTIVE_LOW>; | |
| }; | |
| ... |