| // SPDX-License-Identifier: GPL-2.0-only | |
| #include <linux/ethtool.h> | |
| #include <linux/sfp.h> | |
| #include "common.h" | |
| #include "netlink.h" | |
| struct eeprom_req_info { | |
| struct ethnl_req_info base; | |
| u32 offset; | |
| u32 length; | |
| u8 page; | |
| u8 bank; | |
| u8 i2c_address; | |
| }; | |
| struct eeprom_reply_data { | |
| struct ethnl_reply_data base; | |
| u32 length; | |
| u8 *data; | |
| }; | |
| #define MODULE_EEPROM_REQINFO(__req_base) \ | |
| container_of(__req_base, struct eeprom_req_info, base) | |
| #define MODULE_EEPROM_REPDATA(__reply_base) \ | |
| container_of(__reply_base, struct eeprom_reply_data, base) | |
| static int fallback_set_params(struct eeprom_req_info *request, | |
| struct ethtool_modinfo *modinfo, | |
| struct ethtool_eeprom *eeprom) | |
| { | |
| u32 offset = request->offset; | |
| u32 length = request->length; | |
| if (request->page) | |
| offset = request->page * ETH_MODULE_EEPROM_PAGE_LEN + offset; | |
| if (modinfo->type == ETH_MODULE_SFF_8472 && | |
| request->i2c_address == 0x51) | |
| offset += ETH_MODULE_EEPROM_PAGE_LEN * 2; | |
| if (offset >= modinfo->eeprom_len) | |
| return -EINVAL; | |
| if (length > modinfo->eeprom_len - offset) | |
| return -EINVAL; | |
| eeprom->cmd = ETHTOOL_GMODULEEEPROM; | |
| eeprom->len = length; | |
| eeprom->offset = offset; | |
| return 0; | |
| } | |
| static int eeprom_fallback(struct eeprom_req_info *request, | |
| struct eeprom_reply_data *reply) | |
| { | |
| struct net_device *dev = reply->base.dev; | |
| struct ethtool_modinfo modinfo = {0}; | |
| struct ethtool_eeprom eeprom = {0}; | |
| u8 *data; | |
| int err; | |
| modinfo.cmd = ETHTOOL_GMODULEINFO; | |
| err = ethtool_get_module_info_call(dev, &modinfo); | |
| if (err < 0) | |
| return err; | |
| err = fallback_set_params(request, &modinfo, &eeprom); | |
| if (err < 0) | |
| return err; | |
| data = kzalloc(eeprom.len, GFP_KERNEL); | |
| if (!data) | |
| return -ENOMEM; | |
| err = ethtool_get_module_eeprom_call(dev, &eeprom, data); | |
| if (err < 0) | |
| goto err_out; | |
| reply->data = data; | |
| reply->length = eeprom.len; | |
| return 0; | |
| err_out: | |
| kfree(data); | |
| return err; | |
| } | |
| static int get_module_eeprom_by_page(struct net_device *dev, | |
| struct ethtool_module_eeprom *page_data, | |
| struct netlink_ext_ack *extack) | |
| { | |
| const struct ethtool_ops *ops = dev->ethtool_ops; | |
| if (dev->ethtool->module_fw_flash_in_progress) { | |
| NL_SET_ERR_MSG(extack, | |
| "Module firmware flashing is in progress"); | |
| return -EBUSY; | |
| } | |
| if (dev->sfp_bus) | |
| return sfp_get_module_eeprom_by_page(dev->sfp_bus, page_data, extack); | |
| if (ops->get_module_eeprom_by_page) | |
| return ops->get_module_eeprom_by_page(dev, page_data, extack); | |
| return -EOPNOTSUPP; | |
| } | |
| static int eeprom_prepare_data(const struct ethnl_req_info *req_base, | |
| struct ethnl_reply_data *reply_base, | |
| const struct genl_info *info) | |
| { | |
| struct eeprom_reply_data *reply = MODULE_EEPROM_REPDATA(reply_base); | |
| struct eeprom_req_info *request = MODULE_EEPROM_REQINFO(req_base); | |
| struct ethtool_module_eeprom page_data = {0}; | |
| struct net_device *dev = reply_base->dev; | |
| int ret; | |
| page_data.offset = request->offset; | |
| page_data.length = request->length; | |
| page_data.i2c_address = request->i2c_address; | |
| page_data.page = request->page; | |
| page_data.bank = request->bank; | |
| page_data.data = kmalloc(page_data.length, GFP_KERNEL); | |
| if (!page_data.data) | |
| return -ENOMEM; | |
| ret = ethnl_ops_begin(dev); | |
| if (ret) | |
| goto err_free; | |
| ret = get_module_eeprom_by_page(dev, &page_data, info->extack); | |
| if (ret < 0) | |
| goto err_ops; | |
| reply->length = ret; | |
| reply->data = page_data.data; | |
| ethnl_ops_complete(dev); | |
| return 0; | |
| err_ops: | |
| if (ret == -EOPNOTSUPP) | |
| ret = eeprom_fallback(request, reply); | |
| ethnl_ops_complete(dev); | |
| err_free: | |
| kfree(page_data.data); | |
| return ret; | |
| } | |
| static int eeprom_parse_request(struct ethnl_req_info *req_info, | |
| const struct genl_info *info, | |
| struct nlattr **tb, | |
| struct netlink_ext_ack *extack) | |
| { | |
| struct eeprom_req_info *request = MODULE_EEPROM_REQINFO(req_info); | |
| if (GENL_REQ_ATTR_CHECK(info, ETHTOOL_A_MODULE_EEPROM_OFFSET) || | |
| GENL_REQ_ATTR_CHECK(info, ETHTOOL_A_MODULE_EEPROM_LENGTH) || | |
| GENL_REQ_ATTR_CHECK(info, ETHTOOL_A_MODULE_EEPROM_PAGE) || | |
| GENL_REQ_ATTR_CHECK(info, ETHTOOL_A_MODULE_EEPROM_I2C_ADDRESS)) | |
| return -EINVAL; | |
| request->i2c_address = nla_get_u8(tb[ETHTOOL_A_MODULE_EEPROM_I2C_ADDRESS]); | |
| request->offset = nla_get_u32(tb[ETHTOOL_A_MODULE_EEPROM_OFFSET]); | |
| request->length = nla_get_u32(tb[ETHTOOL_A_MODULE_EEPROM_LENGTH]); | |
| /* The following set of conditions limit the API to only dump 1/2 | |
| * EEPROM page without crossing low page boundary located at offset 128. | |
| * This means user may only request dumps of length limited to 128 from | |
| * either low 128 bytes or high 128 bytes. | |
| * For pages higher than 0 only high 128 bytes are accessible. | |
| */ | |
| request->page = nla_get_u8(tb[ETHTOOL_A_MODULE_EEPROM_PAGE]); | |
| if (request->page && request->offset < ETH_MODULE_EEPROM_PAGE_LEN) { | |
| NL_SET_ERR_MSG_ATTR(extack, tb[ETHTOOL_A_MODULE_EEPROM_PAGE], | |
| "reading from lower half page is allowed for page 0 only"); | |
| return -EINVAL; | |
| } | |
| if (request->offset < ETH_MODULE_EEPROM_PAGE_LEN && | |
| request->offset + request->length > ETH_MODULE_EEPROM_PAGE_LEN) { | |
| NL_SET_ERR_MSG_ATTR(extack, tb[ETHTOOL_A_MODULE_EEPROM_LENGTH], | |
| "reading cross half page boundary is illegal"); | |
| return -EINVAL; | |
| } else if (request->offset + request->length > ETH_MODULE_EEPROM_PAGE_LEN * 2) { | |
| NL_SET_ERR_MSG_ATTR(extack, tb[ETHTOOL_A_MODULE_EEPROM_LENGTH], | |
| "reading cross page boundary is illegal"); | |
| return -EINVAL; | |
| } | |
| if (tb[ETHTOOL_A_MODULE_EEPROM_BANK]) | |
| request->bank = nla_get_u8(tb[ETHTOOL_A_MODULE_EEPROM_BANK]); | |
| return 0; | |
| } | |
| static int eeprom_reply_size(const struct ethnl_req_info *req_base, | |
| const struct ethnl_reply_data *reply_base) | |
| { | |
| const struct eeprom_req_info *request = MODULE_EEPROM_REQINFO(req_base); | |
| return nla_total_size(sizeof(u8) * request->length); /* _EEPROM_DATA */ | |
| } | |
| static int eeprom_fill_reply(struct sk_buff *skb, | |
| const struct ethnl_req_info *req_base, | |
| const struct ethnl_reply_data *reply_base) | |
| { | |
| struct eeprom_reply_data *reply = MODULE_EEPROM_REPDATA(reply_base); | |
| return nla_put(skb, ETHTOOL_A_MODULE_EEPROM_DATA, reply->length, reply->data); | |
| } | |
| static void eeprom_cleanup_data(struct ethnl_reply_data *reply_base) | |
| { | |
| struct eeprom_reply_data *reply = MODULE_EEPROM_REPDATA(reply_base); | |
| kfree(reply->data); | |
| } | |
| const struct ethnl_request_ops ethnl_module_eeprom_request_ops = { | |
| .request_cmd = ETHTOOL_MSG_MODULE_EEPROM_GET, | |
| .reply_cmd = ETHTOOL_MSG_MODULE_EEPROM_GET_REPLY, | |
| .hdr_attr = ETHTOOL_A_MODULE_EEPROM_HEADER, | |
| .req_info_size = sizeof(struct eeprom_req_info), | |
| .reply_data_size = sizeof(struct eeprom_reply_data), | |
| .parse_request = eeprom_parse_request, | |
| .prepare_data = eeprom_prepare_data, | |
| .reply_size = eeprom_reply_size, | |
| .fill_reply = eeprom_fill_reply, | |
| .cleanup_data = eeprom_cleanup_data, | |
| }; | |
| const struct nla_policy ethnl_module_eeprom_get_policy[] = { | |
| [ETHTOOL_A_MODULE_EEPROM_HEADER] = NLA_POLICY_NESTED(ethnl_header_policy), | |
| [ETHTOOL_A_MODULE_EEPROM_OFFSET] = | |
| NLA_POLICY_MAX(NLA_U32, ETH_MODULE_EEPROM_PAGE_LEN * 2 - 1), | |
| [ETHTOOL_A_MODULE_EEPROM_LENGTH] = | |
| NLA_POLICY_RANGE(NLA_U32, 1, ETH_MODULE_EEPROM_PAGE_LEN), | |
| [ETHTOOL_A_MODULE_EEPROM_PAGE] = { .type = NLA_U8 }, | |
| [ETHTOOL_A_MODULE_EEPROM_BANK] = { .type = NLA_U8 }, | |
| [ETHTOOL_A_MODULE_EEPROM_I2C_ADDRESS] = | |
| NLA_POLICY_RANGE(NLA_U8, 0, ETH_MODULE_MAX_I2C_ADDRESS), | |
| }; | |