| /* SPDX-License-Identifier: GPL-2.0-or-later */ | |
| /* | |
| STB0899 Multistandard Frontend driver | |
| Copyright (C) Manu Abraham (abraham.manu@gmail.com) | |
| Copyright (C) ST Microelectronics | |
| */ | |
| #ifndef __STB0899_DRV_H | |
| #define __STB0899_DRV_H | |
| #include <linux/kernel.h> | |
| #include <linux/module.h> | |
| #include <media/dvb_frontend.h> | |
| #define STB0899_TSMODE_SERIAL 1 | |
| #define STB0899_CLKPOL_FALLING 2 | |
| #define STB0899_CLKNULL_PARITY 3 | |
| #define STB0899_SYNC_FORCED 4 | |
| #define STB0899_FECMODE_DSS 5 | |
| struct stb0899_s1_reg { | |
| u16 address; | |
| u8 data; | |
| }; | |
| struct stb0899_s2_reg { | |
| u16 offset; | |
| u32 base_address; | |
| u32 data; | |
| }; | |
| enum stb0899_inversion { | |
| IQ_SWAP_OFF = +1, /* inversion affects the sign of e. g. */ | |
| IQ_SWAP_ON = -1, /* the derotator frequency register */ | |
| }; | |
| #define STB0899_GPIO00 0xf140 | |
| #define STB0899_GPIO01 0xf141 | |
| #define STB0899_GPIO02 0xf142 | |
| #define STB0899_GPIO03 0xf143 | |
| #define STB0899_GPIO04 0xf144 | |
| #define STB0899_GPIO05 0xf145 | |
| #define STB0899_GPIO06 0xf146 | |
| #define STB0899_GPIO07 0xf147 | |
| #define STB0899_GPIO08 0xf148 | |
| #define STB0899_GPIO09 0xf149 | |
| #define STB0899_GPIO10 0xf14a | |
| #define STB0899_GPIO11 0xf14b | |
| #define STB0899_GPIO12 0xf14c | |
| #define STB0899_GPIO13 0xf14d | |
| #define STB0899_GPIO14 0xf14e | |
| #define STB0899_GPIO15 0xf14f | |
| #define STB0899_GPIO16 0xf150 | |
| #define STB0899_GPIO17 0xf151 | |
| #define STB0899_GPIO18 0xf152 | |
| #define STB0899_GPIO19 0xf153 | |
| #define STB0899_GPIO20 0xf154 | |
| #define STB0899_GPIOPULLUP 0x01 /* Output device is connected to Vdd */ | |
| #define STB0899_GPIOPULLDN 0x00 /* Output device is connected to Vss */ | |
| #define STB0899_POSTPROC_GPIO_POWER 0x00 | |
| #define STB0899_POSTPROC_GPIO_LOCK 0x01 | |
| /* | |
| * Post process output configuration control | |
| * 1. POWER ON/OFF (index 0) | |
| * 2. FE_HAS_LOCK/LOCK_LOSS (index 1) | |
| * | |
| * @gpio = one of the above listed GPIO's | |
| * @level = output state: pulled up or low | |
| */ | |
| struct stb0899_postproc { | |
| u16 gpio; | |
| u8 level; | |
| }; | |
| struct stb0899_config { | |
| const struct stb0899_s1_reg *init_dev; | |
| const struct stb0899_s2_reg *init_s2_demod; | |
| const struct stb0899_s1_reg *init_s1_demod; | |
| const struct stb0899_s2_reg *init_s2_fec; | |
| const struct stb0899_s1_reg *init_tst; | |
| const struct stb0899_postproc *postproc; | |
| enum stb0899_inversion inversion; | |
| u32 xtal_freq; | |
| u8 demod_address; | |
| u8 ts_output_mode; | |
| u8 block_sync_mode; | |
| u8 ts_pfbit_toggle; | |
| u8 clock_polarity; | |
| u8 data_clk_parity; | |
| u8 fec_mode; | |
| u8 data_output_ctl; | |
| u8 data_fifo_mode; | |
| u8 out_rate_comp; | |
| u8 i2c_repeater; | |
| // int inversion; | |
| int lo_clk; | |
| int hi_clk; | |
| u32 esno_ave; | |
| u32 esno_quant; | |
| u32 avframes_coarse; | |
| u32 avframes_fine; | |
| u32 miss_threshold; | |
| u32 uwp_threshold_acq; | |
| u32 uwp_threshold_track; | |
| u32 uwp_threshold_sof; | |
| u32 sof_search_timeout; | |
| u32 btr_nco_bits; | |
| u32 btr_gain_shift_offset; | |
| u32 crl_nco_bits; | |
| u32 ldpc_max_iter; | |
| int (*tuner_set_frequency)(struct dvb_frontend *fe, u32 frequency); | |
| int (*tuner_get_frequency)(struct dvb_frontend *fe, u32 *frequency); | |
| int (*tuner_set_bandwidth)(struct dvb_frontend *fe, u32 bandwidth); | |
| int (*tuner_get_bandwidth)(struct dvb_frontend *fe, u32 *bandwidth); | |
| int (*tuner_set_rfsiggain)(struct dvb_frontend *fe, u32 rf_gain); | |
| }; | |
| #if IS_REACHABLE(CONFIG_DVB_STB0899) | |
| extern struct dvb_frontend *stb0899_attach(struct stb0899_config *config, | |
| struct i2c_adapter *i2c); | |
| #else | |
| static inline struct dvb_frontend *stb0899_attach(struct stb0899_config *config, | |
| struct i2c_adapter *i2c) | |
| { | |
| printk(KERN_WARNING "%s: Driver disabled by Kconfig\n", __func__); | |
| return NULL; | |
| } | |
| #endif //CONFIG_DVB_STB0899 | |
| #endif |