| /* SPDX-License-Identifier: GPL-2.0-only */ | |
| /* | |
| * Copyright (C) 2012 Texas Instruments | |
| * Author: Rob Clark <robdclark@gmail.com> | |
| */ | |
| #ifndef __TILCDC_DRV_H__ | |
| #define __TILCDC_DRV_H__ | |
| #include <linux/cpufreq.h> | |
| #include <linux/irqreturn.h> | |
| #include <drm/drm_print.h> | |
| struct clk; | |
| struct workqueue_struct; | |
| struct drm_connector; | |
| struct drm_connector_helper_funcs; | |
| struct drm_crtc; | |
| struct drm_device; | |
| struct drm_display_mode; | |
| struct drm_encoder; | |
| struct drm_framebuffer; | |
| struct drm_minor; | |
| struct drm_pending_vblank_event; | |
| struct drm_plane; | |
| /* Defaulting to pixel clock defined on AM335x */ | |
| #define TILCDC_DEFAULT_MAX_PIXELCLOCK 126000 | |
| /* Maximum display width for LCDC V1 */ | |
| #define TILCDC_DEFAULT_MAX_WIDTH_V1 1024 | |
| /* ... and for LCDC V2 found on AM335x: */ | |
| #define TILCDC_DEFAULT_MAX_WIDTH_V2 2048 | |
| /* | |
| * This may need some tweaking, but want to allow at least 1280x1024@60 | |
| * with optimized DDR & EMIF settings tweaked 1920x1080@24 appears to | |
| * be supportable | |
| */ | |
| #define TILCDC_DEFAULT_MAX_BANDWIDTH (1280*1024*60) | |
| struct tilcdc_drm_private { | |
| void __iomem *mmio; | |
| struct clk *clk; /* functional clock */ | |
| int rev; /* IP revision */ | |
| unsigned int irq; | |
| struct drm_device ddev; | |
| /* don't attempt resolutions w/ higher W * H * Hz: */ | |
| uint32_t max_bandwidth; | |
| /* | |
| * Pixel Clock will be restricted to some value as | |
| * defined in the device datasheet measured in KHz | |
| */ | |
| uint32_t max_pixelclock; | |
| /* | |
| * Max allowable width is limited on a per device basis | |
| * measured in pixels | |
| */ | |
| uint32_t max_width; | |
| u32 fifo_th; | |
| /* Supported pixel formats */ | |
| const uint32_t *pixelformats; | |
| uint32_t num_pixelformats; | |
| #ifdef CONFIG_CPU_FREQ | |
| struct notifier_block freq_transition; | |
| #endif | |
| struct workqueue_struct *wq; | |
| struct drm_crtc *crtc; | |
| struct tilcdc_encoder *encoder; | |
| struct drm_connector *connector; | |
| bool irq_enabled; | |
| }; | |
| #define DBG(fmt, ...) DRM_DEBUG(fmt"\n", ##__VA_ARGS__) | |
| #define ddev_to_tilcdc_priv(x) container_of(x, struct tilcdc_drm_private, ddev) | |
| int tilcdc_crtc_create(struct drm_device *dev); | |
| irqreturn_t tilcdc_crtc_irq(struct drm_crtc *crtc); | |
| void tilcdc_crtc_update_clk(struct drm_crtc *crtc); | |
| void tilcdc_crtc_shutdown(struct drm_crtc *crtc); | |
| int tilcdc_crtc_update_fb(struct drm_crtc *crtc, | |
| struct drm_framebuffer *fb, | |
| struct drm_pending_vblank_event *event); | |
| struct tilcdc_plane { | |
| struct drm_plane base; | |
| }; | |
| struct tilcdc_encoder { | |
| struct drm_encoder base; | |
| }; | |
| struct tilcdc_plane *tilcdc_plane_init(struct drm_device *dev); | |
| #endif /* __TILCDC_DRV_H__ */ |