| // SPDX-License-Identifier: GPL-2.0-or-later | |
| /* | |
| * Atheros Communication Bluetooth HCIATH3K UART protocol | |
| * | |
| * HCIATH3K (HCI Atheros AR300x Protocol) is a Atheros Communication's | |
| * power management protocol extension to H4 to support AR300x Bluetooth Chip. | |
| * | |
| * Copyright (c) 2009-2010 Atheros Communications Inc. | |
| * | |
| * Acknowledgements: | |
| * This file is based on hci_h4.c, which was written | |
| * by Maxim Krasnyansky and Marcel Holtmann. | |
| */ | |
| #include <linux/module.h> | |
| #include <linux/kernel.h> | |
| #include <linux/init.h> | |
| #include <linux/slab.h> | |
| #include <linux/tty.h> | |
| #include <linux/errno.h> | |
| #include <linux/ioctl.h> | |
| #include <linux/skbuff.h> | |
| #include <net/bluetooth/bluetooth.h> | |
| #include <net/bluetooth/hci_core.h> | |
| #include "hci_uart.h" | |
| struct ath_struct { | |
| struct hci_uart *hu; | |
| unsigned int cur_sleep; | |
| struct sk_buff *rx_skb; | |
| struct sk_buff_head txq; | |
| struct work_struct ctxtsw; | |
| }; | |
| #define OP_WRITE_TAG 0x01 | |
| #define INDEX_BDADDR 0x01 | |
| struct ath_vendor_cmd { | |
| __u8 opcode; | |
| __le16 index; | |
| __u8 len; | |
| __u8 data[251]; | |
| } __packed; | |
| static int ath_wakeup_ar3k(struct tty_struct *tty) | |
| { | |
| int status = tty->driver->ops->tiocmget(tty); | |
| if (status & TIOCM_CTS) | |
| return status; | |
| /* Clear RTS first */ | |
| tty->driver->ops->tiocmget(tty); | |
| tty->driver->ops->tiocmset(tty, 0x00, TIOCM_RTS); | |
| msleep(20); | |
| /* Set RTS, wake up board */ | |
| tty->driver->ops->tiocmget(tty); | |
| tty->driver->ops->tiocmset(tty, TIOCM_RTS, 0x00); | |
| msleep(20); | |
| status = tty->driver->ops->tiocmget(tty); | |
| return status; | |
| } | |
| static void ath_hci_uart_work(struct work_struct *work) | |
| { | |
| int status; | |
| struct ath_struct *ath; | |
| struct hci_uart *hu; | |
| struct tty_struct *tty; | |
| ath = container_of(work, struct ath_struct, ctxtsw); | |
| hu = ath->hu; | |
| tty = hu->tty; | |
| /* verify and wake up controller */ | |
| if (ath->cur_sleep) { | |
| status = ath_wakeup_ar3k(tty); | |
| if (!(status & TIOCM_CTS)) | |
| return; | |
| } | |
| /* Ready to send Data */ | |
| clear_bit(HCI_UART_SENDING, &hu->tx_state); | |
| hci_uart_tx_wakeup(hu); | |
| } | |
| static int ath_open(struct hci_uart *hu) | |
| { | |
| struct ath_struct *ath; | |
| BT_DBG("hu %p", hu); | |
| if (!hci_uart_has_flow_control(hu)) | |
| return -EOPNOTSUPP; | |
| ath = kzalloc_obj(*ath); | |
| if (!ath) | |
| return -ENOMEM; | |
| skb_queue_head_init(&ath->txq); | |
| hu->priv = ath; | |
| ath->hu = hu; | |
| INIT_WORK(&ath->ctxtsw, ath_hci_uart_work); | |
| return 0; | |
| } | |
| static int ath_close(struct hci_uart *hu) | |
| { | |
| struct ath_struct *ath = hu->priv; | |
| BT_DBG("hu %p", hu); | |
| skb_queue_purge(&ath->txq); | |
| kfree_skb(ath->rx_skb); | |
| cancel_work_sync(&ath->ctxtsw); | |
| hu->priv = NULL; | |
| kfree(ath); | |
| return 0; | |
| } | |
| static int ath_flush(struct hci_uart *hu) | |
| { | |
| struct ath_struct *ath = hu->priv; | |
| BT_DBG("hu %p", hu); | |
| skb_queue_purge(&ath->txq); | |
| return 0; | |
| } | |
| static int ath_vendor_cmd(struct hci_dev *hdev, uint8_t opcode, uint16_t index, | |
| const void *data, size_t dlen) | |
| { | |
| struct sk_buff *skb; | |
| struct ath_vendor_cmd cmd; | |
| if (dlen > sizeof(cmd.data)) | |
| return -EINVAL; | |
| cmd.opcode = opcode; | |
| cmd.index = cpu_to_le16(index); | |
| cmd.len = dlen; | |
| memcpy(cmd.data, data, dlen); | |
| skb = __hci_cmd_sync(hdev, 0xfc0b, dlen + 4, &cmd, HCI_INIT_TIMEOUT); | |
| if (IS_ERR(skb)) | |
| return PTR_ERR(skb); | |
| kfree_skb(skb); | |
| return 0; | |
| } | |
| static int ath_set_bdaddr(struct hci_dev *hdev, const bdaddr_t *bdaddr) | |
| { | |
| return ath_vendor_cmd(hdev, OP_WRITE_TAG, INDEX_BDADDR, bdaddr, | |
| sizeof(*bdaddr)); | |
| } | |
| static int ath_setup(struct hci_uart *hu) | |
| { | |
| BT_DBG("hu %p", hu); | |
| hu->hdev->set_bdaddr = ath_set_bdaddr; | |
| return 0; | |
| } | |
| static const struct h4_recv_pkt ath_recv_pkts[] = { | |
| { H4_RECV_ACL, .recv = hci_recv_frame }, | |
| { H4_RECV_SCO, .recv = hci_recv_frame }, | |
| { H4_RECV_EVENT, .recv = hci_recv_frame }, | |
| }; | |
| static int ath_recv(struct hci_uart *hu, const void *data, int count) | |
| { | |
| struct ath_struct *ath = hu->priv; | |
| if (!ath) | |
| return -ENODEV; | |
| ath->rx_skb = h4_recv_buf(hu, ath->rx_skb, data, count, | |
| ath_recv_pkts, ARRAY_SIZE(ath_recv_pkts)); | |
| if (IS_ERR(ath->rx_skb)) { | |
| int err = PTR_ERR(ath->rx_skb); | |
| bt_dev_err(hu->hdev, "Frame reassembly failed (%d)", err); | |
| ath->rx_skb = NULL; | |
| return err; | |
| } | |
| return count; | |
| } | |
| #define HCI_OP_ATH_SLEEP 0xFC04 | |
| static int ath_enqueue(struct hci_uart *hu, struct sk_buff *skb) | |
| { | |
| struct ath_struct *ath = hu->priv; | |
| if (hci_skb_pkt_type(skb) == HCI_SCODATA_PKT) { | |
| kfree_skb(skb); | |
| return 0; | |
| } | |
| /* Update power management enable flag with parameters of | |
| * HCI sleep enable vendor specific HCI command. | |
| */ | |
| if (hci_skb_pkt_type(skb) == HCI_COMMAND_PKT) { | |
| struct hci_command_hdr *hdr = (void *)skb->data; | |
| if (__le16_to_cpu(hdr->opcode) == HCI_OP_ATH_SLEEP) | |
| ath->cur_sleep = skb->data[HCI_COMMAND_HDR_SIZE]; | |
| } | |
| BT_DBG("hu %p skb %p", hu, skb); | |
| /* Prepend skb with frame type */ | |
| memcpy(skb_push(skb, 1), &hci_skb_pkt_type(skb), 1); | |
| skb_queue_tail(&ath->txq, skb); | |
| set_bit(HCI_UART_SENDING, &hu->tx_state); | |
| schedule_work(&ath->ctxtsw); | |
| return 0; | |
| } | |
| static struct sk_buff *ath_dequeue(struct hci_uart *hu) | |
| { | |
| struct ath_struct *ath = hu->priv; | |
| return skb_dequeue(&ath->txq); | |
| } | |
| static const struct hci_uart_proto athp = { | |
| .id = HCI_UART_ATH3K, | |
| .name = "ATH3K", | |
| .manufacturer = 69, | |
| .open = ath_open, | |
| .close = ath_close, | |
| .flush = ath_flush, | |
| .setup = ath_setup, | |
| .recv = ath_recv, | |
| .enqueue = ath_enqueue, | |
| .dequeue = ath_dequeue, | |
| }; | |
| int __init ath_init(void) | |
| { | |
| return hci_uart_register_proto(&athp); | |
| } | |
| int __exit ath_deinit(void) | |
| { | |
| return hci_uart_unregister_proto(&athp); | |
| } |