| #!/bin/sh | |
| # SPDX-License-Identifier: GPL-2.0-only | |
| # XIP kernel .data segment compressor | |
| # | |
| # Created by: Nicolas Pitre, August 2017 | |
| # Copyright: (C) 2017 Linaro Limited | |
| # | |
| # This script locates the start of the .data section in xipImage and | |
| # substitutes it with a compressed version. The needed offsets are obtained | |
| # from symbol addresses in vmlinux. It is expected that .data extends to | |
| # the end of xipImage. | |
| set -e | |
| VMLINUX="$1" | |
| XIPIMAGE="$2" | |
| DD="dd status=none" | |
| # Use "make V=1" to debug this script. | |
| case "$KBUILD_VERBOSE" in | |
| *1*) | |
| set -x | |
| ;; | |
| esac | |
| sym_val() { | |
| # extract hex value for symbol in $1 | |
| local val=$($NM "$VMLINUX" 2>/dev/null | sed -n "/ $1\$/{s/ .*$//p;q}") | |
| [ "$val" ] || { echo "can't find $1 in $VMLINUX" 1>&2; exit 1; } | |
| # convert from hex to decimal | |
| echo $((0x$val)) | |
| } | |
| __data_loc=$(sym_val __data_loc) | |
| _edata_loc=$(sym_val _edata_loc) | |
| base_offset=$(sym_val _xiprom) | |
| # convert to file based offsets | |
| data_start=$(($__data_loc - $base_offset)) | |
| data_end=$(($_edata_loc - $base_offset)) | |
| # Make sure data occupies the last part of the file. | |
| file_end=$(${CONFIG_SHELL} "${srctree}/scripts/file-size.sh" "$XIPIMAGE") | |
| if [ "$file_end" != "$data_end" ]; then | |
| printf "end of xipImage doesn't match with _edata_loc (%#x vs %#x)\n" \ | |
| $(($file_end + $base_offset)) $_edata_loc 1>&2 | |
| exit 1; | |
| fi | |
| # be ready to clean up | |
| trap 'rm -f "$XIPIMAGE.tmp"; exit 1' 1 2 3 | |
| # substitute the data section by a compressed version | |
| $DD if="$XIPIMAGE" count=$data_start iflag=count_bytes of="$XIPIMAGE.tmp" | |
| $DD if="$XIPIMAGE" skip=$data_start iflag=skip_bytes | | |
| $KGZIP -9 >> "$XIPIMAGE.tmp" | |
| # replace kernel binary | |
| mv -f "$XIPIMAGE.tmp" "$XIPIMAGE" |