| .. SPDX-License-Identifier: GPL-2.0 | |
| ========================= | |
| octeontx2 devlink support | |
| ========================= | |
| This document describes the devlink features implemented by the ``octeontx2 AF, PF and VF`` | |
| device drivers. | |
| Parameters | |
| ========== | |
| The ``octeontx2 PF and VF`` drivers implement the following driver-specific parameters. | |
| .. list-table:: Driver-specific parameters implemented | |
| :widths: 5 5 5 85 | |
| * - Name | |
| - Type | |
| - Mode | |
| - Description | |
| * - ``mcam_count`` | |
| - u16 | |
| - runtime | |
| - Select number of match CAM entries to be allocated for an interface. | |
| The same is used for ntuple filters of the interface. Supported by | |
| PF and VF drivers. | |
| The ``octeontx2 AF`` driver implements the following driver-specific parameters. | |
| .. list-table:: Driver-specific parameters implemented | |
| :widths: 5 5 5 85 | |
| * - Name | |
| - Type | |
| - Mode | |
| - Description | |
| * - ``dwrr_mtu`` | |
| - u32 | |
| - runtime | |
| - Use to set the quantum which hardware uses for scheduling among transmit queues. | |
| Hardware uses weighted DWRR algorithm to schedule among all transmit queues. | |
| * - ``npc_mcam_high_zone_percent`` | |
| - u8 | |
| - runtime | |
| - Use to set the number of high priority zone entries in NPC MCAM that can be allocated | |
| by a user, out of the three priority zone categories high, mid and low. | |
| * - ``npc_def_rule_cntr`` | |
| - bool | |
| - runtime | |
| - Use to enable or disable hit counters for the default rules in NPC MCAM. | |
| Its not guaranteed that counters gets enabled and mapped to all the default rules, | |
| since the counters are scarce and driver follows a best effort approach. | |
| The default rule serves as the primary packet steering rule for a specific PF or VF, | |
| based on its DMAC address which is installed by AF driver as part of its initialization. | |
| Sample command to read hit counters for default rule from debugfs is as follows, | |
| cat /sys/kernel/debug/cn10k/npc/mcam_rules | |
| * - ``nix_maxlf`` | |
| - u16 | |
| - runtime | |
| - Use to set the maximum number of LFs in NIX hardware block. This would be useful | |
| to increase the availability of default resources allocated to enabled LFs like | |
| MCAM entries for example. | |
| The ``octeontx2 PF`` driver implements the following driver-specific parameters. | |
| .. list-table:: Driver-specific parameters implemented | |
| :widths: 5 5 5 85 | |
| * - Name | |
| - Type | |
| - Mode | |
| - Description | |
| * - ``unicast_filter_count`` | |
| - u8 | |
| - runtime | |
| - Set the maximum number of unicast filters that can be programmed for | |
| the device. This can be used to achieve better device resource | |
| utilization, avoiding over consumption of unused MCAM table entries. |