| .. SPDX-License-Identifier: GPL-2.0 | |
| Kernel driver mp2856 | |
| ==================== | |
| Supported chips: | |
| * MPS MP2856 | |
| Prefix: 'mp2856' | |
| * MPS MP2857 | |
| Prefix: 'mp2857' | |
| Author: | |
| Peter Yin <peter.yin@quantatw.com> | |
| Description | |
| ----------- | |
| This driver implements support for Monolithic Power Systems, Inc. (MPS) | |
| vendor dual-loop, digital, multi-phase controller MP2856/MP2857 | |
| This device: | |
| - Supports up to two power rail. | |
| - Supports two pages 0 and 1 for and also pages 2 for configuration. | |
| - Can configured VOUT readout in direct or VID format and allows | |
| setting of different formats on rails 1 and 2. For VID the following | |
| protocols are available: AMD SVI3 mode with 5-mV/LSB. | |
| Device supports: | |
| - SVID interface. | |
| - AVSBus interface. | |
| Device compliant with: | |
| - PMBus rev 1.3 interface. | |
| Device supports direct format for reading output current, output voltage, | |
| input and output power and temperature. | |
| Device supports linear format for reading input voltage and input power. | |
| Device supports VID and direct formats for reading output voltage. | |
| The below VID modes are supported: AMD SVI3. | |
| The driver provides the following sysfs attributes for current measurements: | |
| - indexes 1 for "iin"; | |
| - indexes 2, 3 for "iout"; | |
| **curr[1-3]_alarm** | |
| **curr[1-3]_input** | |
| **curr[1-3]_label** | |
| The driver provides the following sysfs attributes for voltage measurements. | |
| - indexes 1 for "vin"; | |
| - indexes 2, 3 for "vout"; | |
| **in[1-3]_crit** | |
| **in[1-3]_crit_alarm** | |
| **in[1-3]_input** | |
| **in[1-3]_label** | |
| **in[1-3]_lcrit** | |
| **in[1-3]_lcrit_alarm** | |
| The driver provides the following sysfs attributes for power measurements. | |
| - indexes 1 for "pin"; | |
| - indexes 2, 3 for "pout"; | |
| **power[1-3]_alarm** | |
| **power[1-3]_input** | |
| **power[1-3]_label** | |
| The driver provides the following sysfs attributes for temperature measurements. | |
| **temp[1-2]_crit** | |
| **temp[1-2]_crit_alarm** | |
| **temp[1-2]_input** | |
| **temp[1-2]_max** | |
| **temp[1-2]_max_alarm** |