| Microchip AT42QT1050 Five-channel Touch Sensor IC | |
| The AT42QT1050 (QT1050) is a QTouchADC sensor device. The device can sense from | |
| one to five keys, dependent on mode. The QT1050 includes all signal processing | |
| functions necessary to provide stable sensing under a wide variety of changing | |
| conditions, and the outputs are fully debounced. | |
| The touchkey device node should be placed inside an I2C bus node. | |
| Required properties: | |
| - compatible: Must be "microchip,qt1050" | |
| - reg: The I2C address of the device | |
| - interrupts: The sink for the touchpad's IRQ output, | |
| see ../interrupt-controller/interrupts.txt | |
| Optional properties: | |
| - wakeup-source: touch keys can be used as a wakeup source | |
| Each button (key) is represented as a sub-node: | |
| Each not specified key or key with linux,code set to KEY_RESERVED gets disabled | |
| in HW. | |
| Subnode properties: | |
| - linux,code: Keycode to emit. | |
| - reg: The key number. Valid values: 0, 1, 2, 3, 4. | |
| Optional subnode-properties: | |
| If a optional property is missing or has a invalid value the default value is | |
| taken. | |
| - microchip,pre-charge-time-ns: | |
| Each touchpad need some time to precharge. The value depends on the mechanical | |
| layout. | |
| Valid value range: 0 - 637500; values must be a multiple of 2500; | |
| default is 0. | |
| - microchip,average-samples: | |
| Number of data samples which are averaged for each read. | |
| Valid values: 1, 4, 16, 64, 256, 1024, 4096, 16384; default is 1. | |
| - microchip,average-scaling: | |
| The scaling factor which is used to scale the average-samples. | |
| Valid values: 1, 2, 4, 8, 16, 32, 64, 128; default is 1. | |
| - microchip,threshold: | |
| Number of counts to register a touch detection. | |
| Valid value range: 0 - 255; default is 20. | |
| Example: | |
| QT1050 with 3 non continuous keys, key2 and key4 are disabled. | |
| touchkeys@41 { | |
| compatible = "microchip,qt1050"; | |
| reg = <0x41>; | |
| interrupt-parent = <&gpio0>; | |
| interrupts = <17 IRQ_TYPE_EDGE_FALLING>; | |
| up@0 { | |
| reg = <0>; | |
| linux,code = <KEY_UP>; | |
| microchip,average-samples = <64>; | |
| microchip,average-scaling = <16>; | |
| microchip,pre-charge-time-ns = <10000>; | |
| }; | |
| right@1 { | |
| reg = <1>; | |
| linux,code = <KEY_RIGHT>; | |
| microchip,average-samples = <64>; | |
| microchip,average-scaling = <8>; | |
| }; | |
| down@3 { | |
| reg = <3>; | |
| linux,code = <KEY_DOWN>; | |
| microchip,average-samples = <256>; | |
| microchip,average-scaling = <16>; | |
| }; | |
| }; |