| # |
| # USB Storage driver configuration |
| # |
| |
| comment "NOTE: USB_STORAGE enables SCSI, and 'SCSI disk support' may also be needed; see USB_STORAGE Help for more information" |
| |
| config USB_STORAGE |
| tristate "USB Mass Storage support" |
| depends on USB |
| select SCSI |
| ---help--- |
| Say Y here if you want to connect USB mass storage devices to your |
| computer's USB port. This is the driver you need for USB |
| floppy drives, USB hard disks, USB tape drives, USB CD-ROMs, |
| USB flash devices, and memory sticks, along with |
| similar devices. This driver may also be used for some cameras |
| and card readers. |
| |
| This option 'selects' (turns on, enables) 'SCSI', but you |
| probably also need 'SCSI device support: SCSI disk support' |
| (BLK_DEV_SD) for most USB storage devices. |
| |
| To compile this driver as a module, choose M here: the |
| module will be called usb-storage. |
| |
| config USB_STORAGE_DEBUG |
| bool "USB Mass Storage verbose debug" |
| depends on USB_STORAGE |
| help |
| Say Y here in order to have the USB Mass Storage code generate |
| verbose debugging messages. |
| |
| config USB_STORAGE_RW_DETECT |
| bool "USB Mass Storage Write-Protected Media Detection (EXPERIMENTAL)" |
| depends on USB_STORAGE && EXPERIMENTAL |
| help |
| Say Y here in order to have the USB Mass Storage code indicate to |
| the SCSI layer that using MODE SENSE(6) and MODE SENSE(10) to |
| determine if the media is write-protected is a good thing to do. |
| |
| Many devices have historically had trouble with these commands, |
| hence the default 2.6.x behavior has been to suppress their use. |
| 2.4.x used these commands with (at best) mixed results, often |
| crashing the firmware of the device. However, the SCSI layer now |
| issues these commands in a manner more consistent with other |
| "popular" OSes, in an attempt to improve compatibility. |
| |
| Saying Y here allows these commands to be sent to a USB device. |
| If you find a device this doesn't work for, switch to N and let |
| us know at <usb-storage@lists.one-eyed-alien.net> |
| |
| If you say N here, the kernel will assume that all disk-like USB |
| devices are write-enabled. |
| |
| config USB_STORAGE_DATAFAB |
| bool "Datafab Compact Flash Reader support (EXPERIMENTAL)" |
| depends on USB_STORAGE && EXPERIMENTAL |
| help |
| Support for certain Datafab CompactFlash readers. |
| Datafab has a web page at <http://www.datafabusa.com/>. |
| |
| config USB_STORAGE_FREECOM |
| bool "Freecom USB/ATAPI Bridge support" |
| depends on USB_STORAGE |
| help |
| Support for the Freecom USB to IDE/ATAPI adaptor. |
| Freecom has a web page at <http://www.freecom.de/>. |
| |
| config USB_STORAGE_ISD200 |
| bool "ISD-200 USB/ATA Bridge support" |
| depends on USB_STORAGE && BLK_DEV_IDE |
| ---help--- |
| Say Y here if you want to use USB Mass Store devices based |
| on the In-Systems Design ISD-200 USB/ATA bridge. |
| |
| Some of the products that use this chip are: |
| |
| - Archos Jukebox 6000 |
| - ISD SmartCable for Storage |
| - Taiwan Skymaster CD530U/DEL-0241 IDE bridge |
| - Sony CRX10U CD-R/RW drive |
| - CyQ've CQ8060A CDRW drive |
| - Planex eXtreme Drive RX-25HU USB-IDE cable (not model RX-25U) |
| |
| config USB_STORAGE_DPCM |
| bool "Microtech/ZiO! CompactFlash/SmartMedia support" |
| depends on USB_STORAGE |
| help |
| Say Y here to support the Microtech/ZiO! CompactFlash reader. |
| There is a web page at <http://www.ziocorp.com/products/>. |
| |
| config USB_STORAGE_HP8200e |
| bool "HP CD-Writer 82xx support (EXPERIMENTAL)" |
| depends on USB_STORAGE && EXPERIMENTAL |
| help |
| Say Y here to include additional code to support Hewlett-Packard |
| 8200e/8210e/8230e CD-Writer Plus drives. |
| |
| config USB_STORAGE_SDDR09 |
| bool "SanDisk SDDR-09 (and other SmartMedia) support (EXPERIMENTAL)" |
| depends on USB_STORAGE && EXPERIMENTAL |
| help |
| Say Y here to include additional code to support the Sandisk SDDR-09 |
| SmartMedia reader in the USB Mass Storage driver. |
| Also works for the Microtech Zio! SmartMedia reader. |
| |
| config USB_STORAGE_SDDR55 |
| bool "SanDisk SDDR-55 SmartMedia support (EXPERIMENTAL)" |
| depends on USB_STORAGE && EXPERIMENTAL |
| help |
| Say Y here to include additional code to support the Sandisk SDDR-55 |
| SmartMedia reader in the USB Mass Storage driver. |
| |
| config USB_STORAGE_JUMPSHOT |
| bool "Lexar Jumpshot Compact Flash Reader (EXPERIMENTAL)" |
| depends on USB_STORAGE && EXPERIMENTAL |
| help |
| Say Y here to include additional code to support the Lexar Jumpshot |
| USB CompactFlash reader. |
| |
