| /* SPDX-License-Identifier: GPL-2.0 */ |
| /* |
| * linux/arch/alpha/kernel/pci_impl.h |
| * |
| * This file contains declarations and inline functions for interfacing |
| * with the PCI initialization routines. |
| */ |
| |
| struct pci_dev; |
| struct pci_controller; |
| struct pci_iommu_arena; |
| |
| /* |
| * We can't just blindly use 64K for machines with EISA busses; they |
| * may also have PCI-PCI bridges present, and then we'd configure the |
| * bridge incorrectly. |
| * |
| * Also, we start at 0x8000 or 0x9000, in hopes to get all devices' |
| * IO space areas allocated *before* 0xC000; this is because certain |
| * BIOSes (Millennium for one) use PCI Config space "mechanism #2" |
| * accesses to probe the bus. If a device's registers appear at 0xC000, |
| * it may see an INx/OUTx at that address during BIOS emulation of the |
| * VGA BIOS, and some cards, notably Adaptec 2940UW, take mortal offense. |
| */ |
| |
| #define EISA_DEFAULT_IO_BASE 0x9000 /* start above 8th slot */ |
| #define DEFAULT_IO_BASE 0x8000 /* start at 8th slot */ |
| |
| /* |
| * We try to make the DEFAULT_MEM_BASE addresses *always* have more than |
| * a single bit set. This is so that devices like the broken Myrinet card |
| * will always have a PCI memory address that will never match a IDSEL |
| * address in PCI Config space, which can cause problems with early rev cards. |
| */ |
| |
| /* |
| * An XL is AVANTI (APECS) family, *but* it has only 27 bits of ISA address |
| * that get passed through the PCI<->ISA bridge chip. Although this causes |
| * us to set the PCI->Mem window bases lower than normal, we still allocate |
| * PCI bus devices' memory addresses *below* the low DMA mapping window, |
| * and hope they fit below 64Mb (to avoid conflicts), and so that they can |
| * be accessed via SPARSE space. |
| * |
| * We accept the risk that a broken Myrinet card will be put into a true XL |
| * and thus can more easily run into the problem described below. |
| */ |
| #define XL_DEFAULT_MEM_BASE ((16+2)*1024*1024) /* 16M to 64M-1 is avail */ |
| |
| /* |
| * APECS and LCA have only 34 bits for physical addresses, thus limiting PCI |
| * bus memory addresses for SPARSE access to be less than 128Mb. |
| */ |
| #define APECS_AND_LCA_DEFAULT_MEM_BASE ((16+2)*1024*1024) |
| |
| /* |
| * Because MCPCIA and T2 core logic support more bits for |
| * physical addresses, they should allow an expanded range of SPARSE |
| * memory addresses. However, we do not use them all, in order to |
| * avoid the HAE manipulation that would be needed. |
| */ |
| #define MCPCIA_DEFAULT_MEM_BASE ((32+2)*1024*1024) |
| #define T2_DEFAULT_MEM_BASE ((16+1)*1024*1024) |
| |
| /* |
| * Because CIA and PYXIS have more bits for physical addresses, |
| * they support an expanded range of SPARSE memory addresses. |
| */ |
| #define DEFAULT_MEM_BASE ((128+16)*1024*1024) |
| |
| /* ??? Experimenting with no HAE for CIA. */ |
| #define CIA_DEFAULT_MEM_BASE ((32+2)*1024*1024) |
| |
| #define IRONGATE_DEFAULT_MEM_BASE ((256*8-16)*1024*1024) |
| |
| #define DEFAULT_AGP_APER_SIZE (64*1024*1024) |
| |
| /* |
| * A small note about bridges and interrupts. The DECchip 21050 (and |
| * later) adheres to the PCI-PCI bridge specification. This says that |
| * the interrupts on the other side of a bridge are swizzled in the |
| * following manner: |
| * |
| * Dev Interrupt Interrupt |
| * Pin on Pin on |
| * Device Connector |
| * |
| * 4 A A |
| * B B |
| * C C |
| * D D |
| * |
| * 5 A B |
| * B C |
| * C D |
| * D A |
| * |
| * 6 A C |
| * B D |
| * C A |
| * D B |
| * |
| * 7 A D |
| * B A |
| * C B |
| * D C |
| * |
| * Where A = pin 1, B = pin 2 and so on and pin=0 = default = A. |
| * Thus, each swizzle is ((pin-1) + (device#-4)) % 4 |
| * |
| * pci_swizzle_interrupt_pin() swizzles for exactly one bridge. The routine |
| * pci_common_swizzle() handles multiple bridges. But there are a |
| * couple boards that do strange things. |
| */ |
| |
| |
| /* The following macro is used to implement the table-based irq mapping |
| function for all single-bus Alphas. */ |
| |
| #define COMMON_TABLE_LOOKUP \ |
| ({ long _ctl_ = -1; \ |
| if (slot >= min_idsel && slot <= max_idsel && pin < irqs_per_slot) \ |
| _ctl_ = irq_tab[slot - min_idsel][pin]; \ |
| _ctl_; }) |
| |
| |
| /* A PCI IOMMU allocation arena. There are typically two of these |
| regions per bus. */ |
| /* ??? The 8400 has a 32-byte pte entry, and the entire table apparently |
| lives directly on the host bridge (no tlb?). We don't support this |
| machine, but if we ever did, we'd need to parameterize all this quite |
| a bit further. Probably with per-bus operation tables. */ |
| |
| struct pci_iommu_arena |
| { |
| spinlock_t lock; |
| struct pci_controller *hose; |
| #define IOMMU_INVALID_PTE 0x2 /* 32:63 bits MBZ */ |
| #define IOMMU_RESERVED_PTE 0xface |
| unsigned long *ptes; |
| dma_addr_t dma_base; |
| unsigned int size; |
| unsigned int next_entry; |
| unsigned int align_entry; |
| }; |
| |
| #if defined(CONFIG_ALPHA_SRM) && \ |
| (defined(CONFIG_ALPHA_CIA) || defined(CONFIG_ALPHA_LCA) || \ |
| defined(CONFIG_ALPHA_AVANTI)) |
| # define NEED_SRM_SAVE_RESTORE |
| #else |
| # undef NEED_SRM_SAVE_RESTORE |
| #endif |
| |
| #if defined(CONFIG_ALPHA_GENERIC) || defined(NEED_SRM_SAVE_RESTORE) |
| # define ALPHA_RESTORE_SRM_SETUP |
| #else |
| # undef ALPHA_RESTORE_SRM_SETUP |
| #endif |
| |
| #ifdef ALPHA_RESTORE_SRM_SETUP |
| extern void pci_restore_srm_config(void); |
| #else |
| #define pci_restore_srm_config() do {} while (0) |
| #endif |
| |
| /* The hose list. */ |
| extern struct pci_controller *hose_head, **hose_tail; |
| extern struct pci_controller *pci_isa_hose; |
| |
| extern unsigned long alpha_agpgart_size; |
| |
| extern void common_init_pci(void); |
| #define common_swizzle pci_common_swizzle |
| extern struct pci_controller *alloc_pci_controller(void); |
| extern struct resource *alloc_resource(void); |
| |
| extern struct pci_iommu_arena *iommu_arena_new_node(int, |
| struct pci_controller *, |
| dma_addr_t, unsigned long, |
| unsigned long); |
| extern struct pci_iommu_arena *iommu_arena_new(struct pci_controller *, |
| dma_addr_t, unsigned long, |
| unsigned long); |
| extern const char *const pci_io_names[]; |
| extern const char *const pci_mem_names[]; |
| extern const char pci_hae0_name[]; |
| |
| extern unsigned long size_for_memory(unsigned long max); |
| |
| extern int iommu_reserve(struct pci_iommu_arena *, long, long); |
| extern int iommu_release(struct pci_iommu_arena *, long, long); |
| extern int iommu_bind(struct pci_iommu_arena *, long, long, struct page **); |
| extern int iommu_unbind(struct pci_iommu_arena *, long, long); |
| |
| |