| /* | |
| * Linux ARCnet driver - "raw mode" packet encapsulation (no soft headers) | |
| * | |
| * Written 1994-1999 by Avery Pennarun. | |
| * Derived from skeleton.c by Donald Becker. | |
| * | |
| * Special thanks to Contemporary Controls, Inc. (www.ccontrols.com) | |
| * for sponsoring the further development of this driver. | |
| * | |
| * ********************** | |
| * | |
| * The original copyright of skeleton.c was as follows: | |
| * | |
| * skeleton.c Written 1993 by Donald Becker. | |
| * Copyright 1993 United States Government as represented by the | |
| * Director, National Security Agency. This software may only be used | |
| * and distributed according to the terms of the GNU General Public License as | |
| * modified by SRC, incorporated herein by reference. | |
| * | |
| * ********************** | |
| * | |
| * For more details, see drivers/net/arcnet.c | |
| * | |
| * ********************** | |
| */ | |
| #define pr_fmt(fmt) "arcnet:" KBUILD_MODNAME ": " fmt | |
| #include <linux/module.h> | |
| #include <linux/gfp.h> | |
| #include <linux/init.h> | |
| #include <linux/if_arp.h> | |
| #include <net/arp.h> | |
| #include <linux/netdevice.h> | |
| #include <linux/skbuff.h> | |
| #include "arcdevice.h" | |
| /* packet receiver */ | |
| static void rx(struct net_device *dev, int bufnum, | |
| struct archdr *pkthdr, int length) | |
| { | |
| struct arcnet_local *lp = netdev_priv(dev); | |
| struct sk_buff *skb; | |
| struct archdr *pkt = pkthdr; | |
| int ofs; | |
| arc_printk(D_DURING, dev, "it's a raw packet (length=%d)\n", length); | |
| if (length > MTU) | |
| ofs = 512 - length; | |
| else | |
| ofs = 256 - length; | |
| skb = alloc_skb(length + ARC_HDR_SIZE, GFP_ATOMIC); | |
| if (!skb) { | |
| dev->stats.rx_dropped++; | |
| return; | |
| } | |
| skb_put(skb, length + ARC_HDR_SIZE); | |
| skb->dev = dev; | |
| pkt = (struct archdr *)skb->data; | |
| skb_reset_mac_header(skb); | |
| skb_pull(skb, ARC_HDR_SIZE); | |
| /* up to sizeof(pkt->soft) has already been copied from the card */ | |
| memcpy(pkt, pkthdr, sizeof(struct archdr)); | |
| if (length > sizeof(pkt->soft)) | |
| lp->hw.copy_from_card(dev, bufnum, ofs + sizeof(pkt->soft), | |
| pkt->soft.raw + sizeof(pkt->soft), | |
| length - sizeof(pkt->soft)); | |
| if (BUGLVL(D_SKB)) | |
| arcnet_dump_skb(dev, skb, "rx"); | |
| skb->protocol = cpu_to_be16(ETH_P_ARCNET); | |
| netif_rx(skb); | |
| } | |
| /* Create the ARCnet hard/soft headers for raw mode. | |
| * There aren't any soft headers in raw mode - not even the protocol id. | |
| */ | |
| static int build_header(struct sk_buff *skb, struct net_device *dev, | |
| unsigned short type, uint8_t daddr) | |
| { | |
| int hdr_size = ARC_HDR_SIZE; | |
| struct archdr *pkt = skb_push(skb, hdr_size); | |
| /* Set the source hardware address. | |
| * | |
| * This is pretty pointless for most purposes, but it can help in | |
| * debugging. ARCnet does not allow us to change the source address | |
| * in the actual packet sent. | |
| */ | |
| pkt->hard.source = *dev->dev_addr; | |
| /* see linux/net/ethernet/eth.c to see where I got the following */ | |
| if (dev->flags & (IFF_LOOPBACK | IFF_NOARP)) { | |
| /* FIXME: fill in the last byte of the dest ipaddr here | |
| * to better comply with RFC1051 in "noarp" mode. | |
| */ | |
| pkt->hard.dest = 0; | |
| return hdr_size; | |
| } | |
| /* otherwise, just fill it in and go! */ | |
| pkt->hard.dest = daddr; | |
| return hdr_size; /* success */ | |
| } | |
| static int prepare_tx(struct net_device *dev, struct archdr *pkt, int length, | |
| int bufnum) | |
| { | |
| struct arcnet_local *lp = netdev_priv(dev); | |
| struct arc_hardware *hard = &pkt->hard; | |
| int ofs; | |
| arc_printk(D_DURING, dev, "prepare_tx: txbufs=%d/%d/%d\n", | |
| lp->next_tx, lp->cur_tx, bufnum); | |
| /* hard header is not included in packet length */ | |
| length -= ARC_HDR_SIZE; | |
| if (length > XMTU) { | |
| /* should never happen! other people already check for this. */ | |
| arc_printk(D_NORMAL, dev, "Bug! prepare_tx with size %d (> %d)\n", | |
| length, XMTU); | |
| length = XMTU; | |
| } | |
| if (length >= MinTU) { | |
| hard->offset[0] = 0; | |
| hard->offset[1] = ofs = 512 - length; | |
| } else if (length > MTU) { | |
| hard->offset[0] = 0; | |
| hard->offset[1] = ofs = 512 - length - 3; | |
| } else { | |
| hard->offset[0] = ofs = 256 - length; | |
| } | |
| arc_printk(D_DURING, dev, "prepare_tx: length=%d ofs=%d\n", | |
| length, ofs); | |
| lp->hw.copy_to_card(dev, bufnum, 0, hard, ARC_HDR_SIZE); | |
| lp->hw.copy_to_card(dev, bufnum, ofs, &pkt->soft, length); | |
| lp->lastload_dest = hard->dest; | |
| return 1; /* done */ | |
| } | |
| static struct ArcProto rawmode_proto = { | |
| .suffix = 'r', | |
| .mtu = XMTU, | |
| .rx = rx, | |
| .build_header = build_header, | |
| .prepare_tx = prepare_tx, | |
| .continue_tx = NULL, | |
| .ack_tx = NULL | |
| }; | |
| static int __init arcnet_raw_init(void) | |
| { | |
| int count; | |
| pr_info("raw mode (`r') encapsulation support loaded\n"); | |
| for (count = 0; count < 256; count++) | |
| if (arc_proto_map[count] == arc_proto_default) | |
| arc_proto_map[count] = &rawmode_proto; | |
| /* for raw mode, we only set the bcast proto if there's no better one */ | |
| if (arc_bcast_proto == arc_proto_default) | |
| arc_bcast_proto = &rawmode_proto; | |
| arc_proto_default = &rawmode_proto; | |
| return 0; | |
| } | |
| static void __exit arcnet_raw_exit(void) | |
| { | |
| arcnet_unregister_proto(&rawmode_proto); | |
| } | |
| module_init(arcnet_raw_init); | |
| module_exit(arcnet_raw_exit); | |
| MODULE_LICENSE("GPL"); |