| /* SPDX-License-Identifier: GPL-2.0 */ |
| #ifndef DW_SPI_HEADER_H |
| #define DW_SPI_HEADER_H |
| |
| #include <linux/io.h> |
| #include <linux/scatterlist.h> |
| #include <linux/gpio.h> |
| |
| /* Register offsets */ |
| #define DW_SPI_CTRL0 0x00 |
| #define DW_SPI_CTRL1 0x04 |
| #define DW_SPI_SSIENR 0x08 |
| #define DW_SPI_MWCR 0x0c |
| #define DW_SPI_SER 0x10 |
| #define DW_SPI_BAUDR 0x14 |
| #define DW_SPI_TXFLTR 0x18 |
| #define DW_SPI_RXFLTR 0x1c |
| #define DW_SPI_TXFLR 0x20 |
| #define DW_SPI_RXFLR 0x24 |
| #define DW_SPI_SR 0x28 |
| #define DW_SPI_IMR 0x2c |
| #define DW_SPI_ISR 0x30 |
| #define DW_SPI_RISR 0x34 |
| #define DW_SPI_TXOICR 0x38 |
| #define DW_SPI_RXOICR 0x3c |
| #define DW_SPI_RXUICR 0x40 |
| #define DW_SPI_MSTICR 0x44 |
| #define DW_SPI_ICR 0x48 |
| #define DW_SPI_DMACR 0x4c |
| #define DW_SPI_DMATDLR 0x50 |
| #define DW_SPI_DMARDLR 0x54 |
| #define DW_SPI_IDR 0x58 |
| #define DW_SPI_VERSION 0x5c |
| #define DW_SPI_DR 0x60 |
| |
| /* Bit fields in CTRLR0 */ |
| #define SPI_DFS_OFFSET 0 |
| |
| #define SPI_FRF_OFFSET 4 |
| #define SPI_FRF_SPI 0x0 |
| #define SPI_FRF_SSP 0x1 |
| #define SPI_FRF_MICROWIRE 0x2 |
| #define SPI_FRF_RESV 0x3 |
| |
| #define SPI_MODE_OFFSET 6 |
| #define SPI_SCPH_OFFSET 6 |
| #define SPI_SCOL_OFFSET 7 |
| |
| #define SPI_TMOD_OFFSET 8 |
| #define SPI_TMOD_MASK (0x3 << SPI_TMOD_OFFSET) |
| #define SPI_TMOD_TR 0x0 /* xmit & recv */ |
| #define SPI_TMOD_TO 0x1 /* xmit only */ |
| #define SPI_TMOD_RO 0x2 /* recv only */ |
| #define SPI_TMOD_EPROMREAD 0x3 /* eeprom read mode */ |
| |
| #define SPI_SLVOE_OFFSET 10 |
| #define SPI_SRL_OFFSET 11 |
| #define SPI_CFS_OFFSET 12 |
| |
| /* Bit fields in SR, 7 bits */ |
| #define SR_MASK 0x7f /* cover 7 bits */ |
| #define SR_BUSY (1 << 0) |
| #define SR_TF_NOT_FULL (1 << 1) |
| #define SR_TF_EMPT (1 << 2) |
| #define SR_RF_NOT_EMPT (1 << 3) |
| #define SR_RF_FULL (1 << 4) |
| #define SR_TX_ERR (1 << 5) |
| #define SR_DCOL (1 << 6) |
| |
| /* Bit fields in ISR, IMR, RISR, 7 bits */ |
| #define SPI_INT_TXEI (1 << 0) |
| #define SPI_INT_TXOI (1 << 1) |
| #define SPI_INT_RXUI (1 << 2) |
| #define SPI_INT_RXOI (1 << 3) |
| #define SPI_INT_RXFI (1 << 4) |
| #define SPI_INT_MSTI (1 << 5) |
| |
| /* Bit fields in DMACR */ |
| #define SPI_DMA_RDMAE (1 << 0) |
| #define SPI_DMA_TDMAE (1 << 1) |
| |
| /* TX RX interrupt level threshold, max can be 256 */ |
| #define SPI_INT_THRESHOLD 32 |
| |
| enum dw_ssi_type { |
| SSI_MOTO_SPI = 0, |
| SSI_TI_SSP, |
| SSI_NS_MICROWIRE, |
| }; |
| |
| struct dw_spi; |
| struct dw_spi_dma_ops { |
| int (*dma_init)(struct dw_spi *dws); |
| void (*dma_exit)(struct dw_spi *dws); |
| int (*dma_setup)(struct dw_spi *dws, struct spi_transfer *xfer); |
| bool (*can_dma)(struct spi_controller *master, struct spi_device *spi, |
| struct spi_transfer *xfer); |
| int (*dma_transfer)(struct dw_spi *dws, struct spi_transfer *xfer); |
| void (*dma_stop)(struct dw_spi *dws); |
| }; |
| |
| struct dw_spi { |
| struct spi_controller *master; |
| enum dw_ssi_type type; |
| |
| void __iomem *regs; |
| unsigned long paddr; |
| int irq; |
| u32 fifo_len; /* depth of the FIFO buffer */ |
| u32 max_freq; /* max bus freq supported */ |
| |
| u32 reg_io_width; /* DR I/O width in bytes */ |
| u16 bus_num; |
| u16 num_cs; /* supported slave numbers */ |
| |
| /* Current message transfer state info */ |
| size_t len; |
| void *tx; |
| void *tx_end; |
| void *rx; |
| void *rx_end; |
| int dma_mapped; |
| u8 n_bytes; /* current is a 1/2 bytes op */ |
| u32 dma_width; |
| irqreturn_t (*transfer_handler)(struct dw_spi *dws); |
| u32 current_freq; /* frequency in hz */ |
| |
| /* DMA info */ |
| int dma_inited; |
| struct dma_chan *txchan; |
| struct dma_chan *rxchan; |
| unsigned long dma_chan_busy; |
| dma_addr_t dma_addr; /* phy address of the Data register */ |
| const struct dw_spi_dma_ops *dma_ops; |
| void *dma_tx; |
| void *dma_rx; |
| |
| /* Bus interface info */ |
| void *priv; |
| #ifdef CONFIG_DEBUG_FS |
| struct dentry *debugfs; |
| #endif |
| }; |
| |
| static inline u32 dw_readl(struct dw_spi *dws, u32 offset) |
| { |
| return __raw_readl(dws->regs + offset); |
| } |
| |
| static inline u16 dw_readw(struct dw_spi *dws, u32 offset) |
| { |
| return __raw_readw(dws->regs + offset); |
| } |
| |
| static inline void dw_writel(struct dw_spi *dws, u32 offset, u32 val) |
| { |
| __raw_writel(val, dws->regs + offset); |
| } |
| |
| static inline void dw_writew(struct dw_spi *dws, u32 offset, u16 val) |
| { |
| __raw_writew(val, dws->regs + offset); |
| } |
| |
| static inline u32 dw_read_io_reg(struct dw_spi *dws, u32 offset) |
| { |
| switch (dws->reg_io_width) { |
| case 2: |
| return dw_readw(dws, offset); |
| case 4: |
| default: |
| return dw_readl(dws, offset); |
| } |
| } |
| |
| static inline void dw_write_io_reg(struct dw_spi *dws, u32 offset, u32 val) |
| { |
| switch (dws->reg_io_width) { |
| case 2: |
| dw_writew(dws, offset, val); |
| break; |
| case 4: |
| default: |
| dw_writel(dws, offset, val); |
| break; |
| } |
| } |
| |
| static inline void spi_enable_chip(struct dw_spi *dws, int enable) |
| { |
| dw_writel(dws, DW_SPI_SSIENR, (enable ? 1 : 0)); |
| } |
| |
| static inline void spi_set_clk(struct dw_spi *dws, u16 div) |
| { |
| dw_writel(dws, DW_SPI_BAUDR, div); |
| } |
| |
| /* Disable IRQ bits */ |
| static inline void spi_mask_intr(struct dw_spi *dws, u32 mask) |
| { |
| u32 new_mask; |
| |
| new_mask = dw_readl(dws, DW_SPI_IMR) & ~mask; |
| dw_writel(dws, DW_SPI_IMR, new_mask); |
| } |
| |
| /* Enable IRQ bits */ |
| static inline void spi_umask_intr(struct dw_spi *dws, u32 mask) |
| { |
| u32 new_mask; |
| |
| new_mask = dw_readl(dws, DW_SPI_IMR) | mask; |
| dw_writel(dws, DW_SPI_IMR, new_mask); |
| } |
| |
| /* |
| * This does disable the SPI controller, interrupts, and re-enable the |
| * controller back. Transmit and receive FIFO buffers are cleared when the |
| * device is disabled. |
| */ |
| static inline void spi_reset_chip(struct dw_spi *dws) |
| { |
| spi_enable_chip(dws, 0); |
| spi_mask_intr(dws, 0xff); |
| spi_enable_chip(dws, 1); |
| } |
| |
| static inline void spi_shutdown_chip(struct dw_spi *dws) |
| { |
| spi_enable_chip(dws, 0); |
| spi_set_clk(dws, 0); |
| } |
| |
| /* |
| * Each SPI slave device to work with dw_api controller should |
| * has such a structure claiming its working mode (poll or PIO/DMA), |
| * which can be save in the "controller_data" member of the |
| * struct spi_device. |
| */ |
| struct dw_spi_chip { |
| u8 poll_mode; /* 1 for controller polling mode */ |
| u8 type; /* SPI/SSP/MicroWire */ |
| void (*cs_control)(u32 command); |
| }; |
| |
| extern int dw_spi_add_host(struct device *dev, struct dw_spi *dws); |
| extern void dw_spi_remove_host(struct dw_spi *dws); |
| extern int dw_spi_suspend_host(struct dw_spi *dws); |
| extern int dw_spi_resume_host(struct dw_spi *dws); |
| |
| /* platform related setup */ |
| extern int dw_spi_mid_init(struct dw_spi *dws); /* Intel MID platforms */ |
| #endif /* DW_SPI_HEADER_H */ |