| // SPDX-License-Identifier: GPL-2.0-only |
| /* |
| * FPGA Manager Driver for Lattice iCE40. |
| * |
| * Copyright (c) 2016 Joel Holdsworth |
| * |
| * This driver adds support to the FPGA manager for configuring the SRAM of |
| * Lattice iCE40 FPGAs through slave SPI. |
| */ |
| |
| #include <linux/fpga/fpga-mgr.h> |
| #include <linux/gpio/consumer.h> |
| #include <linux/module.h> |
| #include <linux/of_gpio.h> |
| #include <linux/spi/spi.h> |
| #include <linux/stringify.h> |
| |
| #define ICE40_SPI_MAX_SPEED 25000000 /* Hz */ |
| #define ICE40_SPI_MIN_SPEED 1000000 /* Hz */ |
| |
| #define ICE40_SPI_RESET_DELAY 1 /* us (>200ns) */ |
| #define ICE40_SPI_HOUSEKEEPING_DELAY 1200 /* us */ |
| |
| #define ICE40_SPI_NUM_ACTIVATION_BYTES DIV_ROUND_UP(49, 8) |
| |
| struct ice40_fpga_priv { |
| struct spi_device *dev; |
| struct gpio_desc *reset; |
| struct gpio_desc *cdone; |
| }; |
| |
| static enum fpga_mgr_states ice40_fpga_ops_state(struct fpga_manager *mgr) |
| { |
| struct ice40_fpga_priv *priv = mgr->priv; |
| |
| return gpiod_get_value(priv->cdone) ? FPGA_MGR_STATE_OPERATING : |
| FPGA_MGR_STATE_UNKNOWN; |
| } |
| |
| static int ice40_fpga_ops_write_init(struct fpga_manager *mgr, |
| struct fpga_image_info *info, |
| const char *buf, size_t count) |
| { |
| struct ice40_fpga_priv *priv = mgr->priv; |
| struct spi_device *dev = priv->dev; |
| struct spi_message message; |
| struct spi_transfer assert_cs_then_reset_delay = { |
| .cs_change = 1, |
| .delay_usecs = ICE40_SPI_RESET_DELAY |
| }; |
| struct spi_transfer housekeeping_delay_then_release_cs = { |
| .delay_usecs = ICE40_SPI_HOUSEKEEPING_DELAY |
| }; |
| int ret; |
| |
| if ((info->flags & FPGA_MGR_PARTIAL_RECONFIG)) { |
| dev_err(&dev->dev, |
| "Partial reconfiguration is not supported\n"); |
| return -ENOTSUPP; |
| } |
| |
| /* Lock the bus, assert CRESET_B and SS_B and delay >200ns */ |
| spi_bus_lock(dev->master); |
| |
| gpiod_set_value(priv->reset, 1); |
| |
| spi_message_init(&message); |
| spi_message_add_tail(&assert_cs_then_reset_delay, &message); |
| ret = spi_sync_locked(dev, &message); |
| |
| /* Come out of reset */ |
| gpiod_set_value(priv->reset, 0); |
| |
| /* Abort if the chip-select failed */ |
| if (ret) |
| goto fail; |
| |
| /* Check CDONE is de-asserted i.e. the FPGA is reset */ |
| if (gpiod_get_value(priv->cdone)) { |
| dev_err(&dev->dev, "Device reset failed, CDONE is asserted\n"); |
| ret = -EIO; |
| goto fail; |
| } |
| |
| /* Wait for the housekeeping to complete, and release SS_B */ |
| spi_message_init(&message); |
| spi_message_add_tail(&housekeeping_delay_then_release_cs, &message); |
| ret = spi_sync_locked(dev, &message); |
| |
| fail: |
| spi_bus_unlock(dev->master); |
| |
| return ret; |
| } |
| |
| static int ice40_fpga_ops_write(struct fpga_manager *mgr, |
| const char *buf, size_t count) |
| { |
| struct ice40_fpga_priv *priv = mgr->priv; |
| |
| return spi_write(priv->dev, buf, count); |
| } |
| |
| static int ice40_fpga_ops_write_complete(struct fpga_manager *mgr, |
| struct fpga_image_info *info) |
| { |
| struct ice40_fpga_priv *priv = mgr->priv; |
| struct spi_device *dev = priv->dev; |
| const u8 padding[ICE40_SPI_NUM_ACTIVATION_BYTES] = {0}; |
| |
| /* Check CDONE is asserted */ |
| if (!gpiod_get_value(priv->cdone)) { |
| dev_err(&dev->dev, |
| "CDONE was not asserted after firmware transfer\n"); |
| return -EIO; |
| } |
| |
| /* Send of zero-padding to activate the firmware */ |
| return spi_write(dev, padding, sizeof(padding)); |
| } |
| |
| static const struct fpga_manager_ops ice40_fpga_ops = { |
| .state = ice40_fpga_ops_state, |
| .write_init = ice40_fpga_ops_write_init, |
| .write = ice40_fpga_ops_write, |
| .write_complete = ice40_fpga_ops_write_complete, |
| }; |
| |
| static int ice40_fpga_probe(struct spi_device *spi) |
| { |
| struct device *dev = &spi->dev; |
| struct ice40_fpga_priv *priv; |
| struct fpga_manager *mgr; |
| int ret; |
| |
| priv = devm_kzalloc(&spi->dev, sizeof(*priv), GFP_KERNEL); |
| if (!priv) |
| return -ENOMEM; |
| |
| priv->dev = spi; |
| |
| /* Check board setup data. */ |
| if (spi->max_speed_hz > ICE40_SPI_MAX_SPEED) { |
| dev_err(dev, "SPI speed is too high, maximum speed is " |
| __stringify(ICE40_SPI_MAX_SPEED) "\n"); |
| return -EINVAL; |
| } |
| |
| if (spi->max_speed_hz < ICE40_SPI_MIN_SPEED) { |
| dev_err(dev, "SPI speed is too low, minimum speed is " |
| __stringify(ICE40_SPI_MIN_SPEED) "\n"); |
| return -EINVAL; |
| } |
| |
| if (spi->mode & SPI_CPHA) { |
| dev_err(dev, "Bad SPI mode, CPHA not supported\n"); |
| return -EINVAL; |
| } |
| |
| /* Set up the GPIOs */ |
| priv->cdone = devm_gpiod_get(dev, "cdone", GPIOD_IN); |
| if (IS_ERR(priv->cdone)) { |
| ret = PTR_ERR(priv->cdone); |
| dev_err(dev, "Failed to get CDONE GPIO: %d\n", ret); |
| return ret; |
| } |
| |
| priv->reset = devm_gpiod_get(dev, "reset", GPIOD_OUT_HIGH); |
| if (IS_ERR(priv->reset)) { |
| ret = PTR_ERR(priv->reset); |
| dev_err(dev, "Failed to get CRESET_B GPIO: %d\n", ret); |
| return ret; |
| } |
| |
| mgr = devm_fpga_mgr_create(dev, "Lattice iCE40 FPGA Manager", |
| &ice40_fpga_ops, priv); |
| if (!mgr) |
| return -ENOMEM; |
| |
| spi_set_drvdata(spi, mgr); |
| |
| return fpga_mgr_register(mgr); |
| } |
| |
| static int ice40_fpga_remove(struct spi_device *spi) |
| { |
| struct fpga_manager *mgr = spi_get_drvdata(spi); |
| |
| fpga_mgr_unregister(mgr); |
| |
| return 0; |
| } |
| |
| static const struct of_device_id ice40_fpga_of_match[] = { |
| { .compatible = "lattice,ice40-fpga-mgr", }, |
| {}, |
| }; |
| MODULE_DEVICE_TABLE(of, ice40_fpga_of_match); |
| |
| static struct spi_driver ice40_fpga_driver = { |
| .probe = ice40_fpga_probe, |
| .remove = ice40_fpga_remove, |
| .driver = { |
| .name = "ice40spi", |
| .of_match_table = of_match_ptr(ice40_fpga_of_match), |
| }, |
| }; |
| |
| module_spi_driver(ice40_fpga_driver); |
| |
| MODULE_AUTHOR("Joel Holdsworth <joel@airwebreathe.org.uk>"); |
| MODULE_DESCRIPTION("Lattice iCE40 FPGA Manager"); |
| MODULE_LICENSE("GPL v2"); |