| menu "Dallas's 1-wire bus" | |
| config W1 | |
| tristate "Dallas's 1-wire support" | |
| ---help--- | |
| Dallas's 1-wire bus is usefull to connect slow 1-pin devices | |
| such as iButtons and thermal sensors. | |
| If you want W1 support, you should say Y here. | |
| This W1 support can also be built as a module. If so, the module | |
| will be called wire.ko. | |
| config W1_MATROX | |
| tristate "Matrox G400 transport layer for 1-wire" | |
| depends on W1 && PCI | |
| help | |
| Say Y here if you want to communicate with your 1-wire devices | |
| using Matrox's G400 GPIO pins. | |
| This support is also available as a module. If so, the module | |
| will be called matrox_w1.ko. | |
| config W1_DS9490 | |
| tristate "DS9490R transport layer driver" | |
| depends on W1 && USB | |
| help | |
| Say Y here if you want to have a driver for DS9490R UWB <-> W1 bridge. | |
| This support is also available as a module. If so, the module | |
| will be called ds9490r.ko. | |
| config W1_DS9490_BRIDGE | |
| tristate "DS9490R USB <-> W1 transport layer for 1-wire" | |
| depends on W1_DS9490 | |
| help | |
| Say Y here if you want to communicate with your 1-wire devices | |
| using DS9490R USB bridge. | |
| This support is also available as a module. If so, the module | |
| will be called ds_w1_bridge.ko. | |
| config W1_THERM | |
| tristate "Thermal family implementation" | |
| depends on W1 | |
| help | |
| Say Y here if you want to connect 1-wire thermal sensors to you | |
| wire. | |
| config W1_SMEM | |
| tristate "Simple 64bit memory family implementation" | |
| depends on W1 | |
| help | |
| Say Y here if you want to connect 1-wire | |
| simple 64bit memory rom(ds2401/ds2411/ds1990*) to you wire. | |
| endmenu |