| # | |
| # Acorn Network device configuration | |
| # These are for Acorn's Expansion card network interfaces | |
| # | |
| config ARM_AM79C961A | |
| bool "ARM EBSA110 AM79C961A support" | |
| depends on NET_ETHERNET && ARM && ARCH_EBSA110 | |
| select CRC32 | |
| help | |
| If you wish to compile a kernel for the EBSA-110, then you should | |
| always answer Y to this. | |
| config ARM_ETHER1 | |
| tristate "Acorn Ether1 support" | |
| depends on NET_ETHERNET && ARM && ARCH_ACORN | |
| help | |
| If you have an Acorn system with one of these (AKA25) network cards, | |
| you should say Y to this option if you wish to use it with Linux. | |
| config ARM_ETHER3 | |
| tristate "Acorn/ANT Ether3 support" | |
| depends on NET_ETHERNET && ARM && ARCH_ACORN | |
| help | |
| If you have an Acorn system with one of these network cards, you | |
| should say Y to this option if you wish to use it with Linux. | |
| config ARM_ETHERH | |
| tristate "I-cubed EtherH/ANT EtherM support" | |
| depends on NET_ETHERNET && ARM && ARCH_ACORN | |
| select CRC32 | |
| help | |
| If you have an Acorn system with one of these network cards, you | |
| should say Y to this option if you wish to use it with Linux. | |
| config ARM_ETHER00 | |
| tristate "Altera Ether00 support" | |
| depends on NET_ETHERNET && ARM && ARCH_CAMELOT | |
| help | |
| This is the driver for Altera's ether00 ethernet mac IP core. Say | |
| Y here if you want to build support for this into the kernel. It | |
| is also available as a module (say M here) that can be inserted/ | |
| removed from the kernel at the same time as the PLD is configured. | |
| If this driver is running on an epxa10 development board then it | |
| will generate a suitable hw address based on the board serial | |
| number (MTD support is required for this). Otherwise you will | |
| need to set a suitable hw address using ifconfig. |