| // SPDX-License-Identifier: GPL-2.0 |
| /* |
| * Copyright (c) 2013 Jie Liu. |
| * All Rights Reserved. |
| */ |
| #include "xfs.h" |
| #include "xfs_fs.h" |
| #include "xfs_shared.h" |
| #include "xfs_format.h" |
| #include "xfs_log_format.h" |
| #include "xfs_trans_resv.h" |
| #include "xfs_mount.h" |
| #include "xfs_da_format.h" |
| #include "xfs_trans_space.h" |
| #include "xfs_inode.h" |
| #include "xfs_da_btree.h" |
| #include "xfs_attr_leaf.h" |
| #include "xfs_bmap_btree.h" |
| |
| /* |
| * Calculate the maximum length in bytes that would be required for a local |
| * attribute value as large attributes out of line are not logged. |
| */ |
| STATIC int |
| xfs_log_calc_max_attrsetm_res( |
| struct xfs_mount *mp) |
| { |
| int size; |
| int nblks; |
| |
| size = xfs_attr_leaf_entsize_local_max(mp->m_attr_geo->blksize) - |
| MAXNAMELEN - 1; |
| nblks = XFS_DAENTER_SPACE_RES(mp, XFS_ATTR_FORK); |
| nblks += XFS_B_TO_FSB(mp, size); |
| nblks += XFS_NEXTENTADD_SPACE_RES(mp, size, XFS_ATTR_FORK); |
| |
| return M_RES(mp)->tr_attrsetm.tr_logres + |
| M_RES(mp)->tr_attrsetrt.tr_logres * nblks; |
| } |
| |
| /* |
| * Iterate over the log space reservation table to figure out and return |
| * the maximum one in terms of the pre-calculated values which were done |
| * at mount time. |
| */ |
| void |
| xfs_log_get_max_trans_res( |
| struct xfs_mount *mp, |
| struct xfs_trans_res *max_resp) |
| { |
| struct xfs_trans_res *resp; |
| struct xfs_trans_res *end_resp; |
| int log_space = 0; |
| int attr_space; |
| |
| attr_space = xfs_log_calc_max_attrsetm_res(mp); |
| |
| resp = (struct xfs_trans_res *)M_RES(mp); |
| end_resp = (struct xfs_trans_res *)(M_RES(mp) + 1); |
| for (; resp < end_resp; resp++) { |
| int tmp = resp->tr_logcount > 1 ? |
| resp->tr_logres * resp->tr_logcount : |
| resp->tr_logres; |
| if (log_space < tmp) { |
| log_space = tmp; |
| *max_resp = *resp; /* struct copy */ |
| } |
| } |
| |
| if (attr_space > log_space) { |
| *max_resp = M_RES(mp)->tr_attrsetm; /* struct copy */ |
| max_resp->tr_logres = attr_space; |
| } |
| } |
| |
| /* |
| * Calculate the minimum valid log size for the given superblock configuration. |
| * Used to calculate the minimum log size at mkfs time, and to determine if |
| * the log is large enough or not at mount time. Returns the minimum size in |
| * filesystem block size units. |
| */ |
| int |
| xfs_log_calc_minimum_size( |
| struct xfs_mount *mp) |
| { |
| struct xfs_trans_res tres = {0}; |
| int max_logres; |
| int min_logblks = 0; |
| int lsunit = 0; |
| |
| xfs_log_get_max_trans_res(mp, &tres); |
| |
| max_logres = xfs_log_calc_unit_res(mp, tres.tr_logres); |
| if (tres.tr_logcount > 1) |
| max_logres *= tres.tr_logcount; |
| |
| if (xfs_sb_version_haslogv2(&mp->m_sb) && mp->m_sb.sb_logsunit > 1) |
| lsunit = BTOBB(mp->m_sb.sb_logsunit); |
| |
| /* |
| * Two factors should be taken into account for calculating the minimum |
| * log space. |
| * 1) The fundamental limitation is that no single transaction can be |
| * larger than half size of the log. |
| * |
| * From mkfs.xfs, this is considered by the XFS_MIN_LOG_FACTOR |
| * define, which is set to 3. That means we can definitely fit |
| * maximally sized 2 transactions in the log. We'll use this same |
| * value here. |
| * |
| * 2) If the lsunit option is specified, a transaction requires 2 LSU |
| * for the reservation because there are two log writes that can |
| * require padding - the transaction data and the commit record which |
| * are written separately and both can require padding to the LSU. |
| * Consider that we can have an active CIL reservation holding 2*LSU, |
| * but the CIL is not over a push threshold, in this case, if we |
| * don't have enough log space for at one new transaction, which |
| * includes another 2*LSU in the reservation, we will run into dead |
| * loop situation in log space grant procedure. i.e. |
| * xlog_grant_head_wait(). |
| * |
| * Hence the log size needs to be able to contain two maximally sized |
| * and padded transactions, which is (2 * (2 * LSU + maxlres)). |
| * |
| * Also, the log size should be a multiple of the log stripe unit, round |
| * it up to lsunit boundary if lsunit is specified. |
| */ |
| if (lsunit) { |
| min_logblks = roundup_64(BTOBB(max_logres), lsunit) + |
| 2 * lsunit; |
| } else |
| min_logblks = BTOBB(max_logres) + 2 * BBSIZE; |
| min_logblks *= XFS_MIN_LOG_FACTOR; |
| |
| return XFS_BB_TO_FSB(mp, min_logblks); |
| } |