| # | |
| # Phy drivers for STMicro platforms | |
| # | |
| config PHY_MIPHY28LP | |
| tristate "STMicroelectronics MIPHY28LP PHY driver for STiH407" | |
| depends on ARCH_STI | |
| select GENERIC_PHY | |
| help | |
| Enable this to support the miphy transceiver (for SATA/PCIE/USB3) | |
| that is part of STMicroelectronics STiH407 SoC. | |
| config PHY_ST_SPEAR1310_MIPHY | |
| tristate "ST SPEAR1310-MIPHY driver" | |
| select GENERIC_PHY | |
| depends on MACH_SPEAR1310 || COMPILE_TEST | |
| help | |
| Support for ST SPEAr1310 MIPHY which can be used for PCIe and SATA. | |
| config PHY_ST_SPEAR1340_MIPHY | |
| tristate "ST SPEAR1340-MIPHY driver" | |
| select GENERIC_PHY | |
| depends on MACH_SPEAR1340 || COMPILE_TEST | |
| help | |
| Support for ST SPEAr1340 MIPHY which can be used for PCIe and SATA. | |
| config PHY_STIH407_USB | |
| tristate "STMicroelectronics USB2 picoPHY driver for STiH407 family" | |
| depends on RESET_CONTROLLER | |
| depends on ARCH_STI || COMPILE_TEST | |
| select GENERIC_PHY | |
| help | |
| Enable this support to enable the picoPHY device used by USB2 | |
| and USB3 controllers on STMicroelectronics STiH407 SoC families. | |
| config PHY_STM32_USBPHYC | |
| tristate "STMicroelectronics STM32 USB HS PHY Controller driver" | |
| depends on ARCH_STM32 || COMPILE_TEST | |
| select GENERIC_PHY | |
| help | |
| Enable this to support the High-Speed USB transceivers that are part | |
| of some STMicroelectronics STM32 SoCs. | |
| This driver controls the entire USB PHY block: the USB PHY controller | |
| (USBPHYC) and the two 8-bit wide UTMI+ interfaces. First interface is | |
| used by an HS USB Host controller, and the second one is shared | |
| between an HS USB OTG controller and an HS USB Host controller, | |
| selected by a USB switch. |