| * Faraday Technology FTGMAC100 gigabit ethernet controller | |
| Required properties: | |
| - compatible: "faraday,ftgmac100" | |
| Must also contain one of these if used as part of an Aspeed AST2400 | |
| or 2500 family SoC as they have some subtle tweaks to the | |
| implementation: | |
| - "aspeed,ast2400-mac" | |
| - "aspeed,ast2500-mac" | |
| - reg: Address and length of the register set for the device | |
| - interrupts: Should contain ethernet controller interrupt | |
| Optional properties: | |
| - phy-mode: See ethernet.txt file in the same directory. If the property is | |
| absent, "rgmii" is assumed. Supported values are "rgmii*" and "rmii" for | |
| aspeed parts. Other (unknown) parts will accept any value. | |
| - use-ncsi: Use the NC-SI stack instead of an MDIO PHY. Currently assumes | |
| rmii (100bT) but kept as a separate property in case NC-SI grows support | |
| for a gigabit link. | |
| - no-hw-checksum: Used to disable HW checksum support. Here for backward | |
| compatibility as the driver now should have correct defaults based on | |
| the SoC. | |
| Example: | |
| mac0: ethernet@1e660000 { | |
| compatible = "aspeed,ast2500-mac", "faraday,ftgmac100"; | |
| reg = <0x1e660000 0x180>; | |
| interrupts = <2>; | |
| use-ncsi; | |
| }; |