| RT5659/RT5658 audio CODEC |
| |
| This device supports I2C only. |
| |
| Required properties: |
| |
| - compatible : One of "realtek,rt5659" or "realtek,rt5658". |
| |
| - reg : The I2C address of the device. |
| |
| - interrupts : The CODEC's interrupt output. |
| |
| Optional properties: |
| |
| - clocks: The phandle of the master clock to the CODEC |
| - clock-names: Should be "mclk" |
| |
| - realtek,in1-differential |
| - realtek,in3-differential |
| - realtek,in4-differential |
| Boolean. Indicate MIC1/3/4 input are differential, rather than single-ended. |
| |
| - realtek,dmic1-data-pin |
| 0: dmic1 is not used |
| 1: using IN2N pin as dmic1 data pin |
| 2: using GPIO5 pin as dmic1 data pin |
| 3: using GPIO9 pin as dmic1 data pin |
| 4: using GPIO11 pin as dmic1 data pin |
| |
| - realtek,dmic2-data-pin |
| 0: dmic2 is not used |
| 1: using IN2P pin as dmic2 data pin |
| 2: using GPIO6 pin as dmic2 data pin |
| 3: using GPIO10 pin as dmic2 data pin |
| 4: using GPIO12 pin as dmic2 data pin |
| |
| - realtek,jd-src |
| 0: No JD is used |
| 1: using JD3 as JD source |
| |
| - realtek,ldo1-en-gpios : The GPIO that controls the CODEC's LDO1_EN pin. |
| - realtek,reset-gpios : The GPIO that controls the CODEC's RESET pin. |
| |
| Pins on the device (for linking into audio routes) for RT5659/RT5658: |
| |
| * DMIC L1 |
| * DMIC R1 |
| * DMIC L2 |
| * DMIC R2 |
| * IN1P |
| * IN1N |
| * IN2P |
| * IN2N |
| * IN3P |
| * IN3N |
| * IN4P |
| * IN4N |
| * HPOL |
| * HPOR |
| * SPOL |
| * SPOR |
| * LOUTL |
| * LOUTR |
| * MONOOUT |
| * PDML |
| * PDMR |
| * SPDIF |
| |
| Example: |
| |
| rt5659 { |
| compatible = "realtek,rt5659"; |
| reg = <0x1b>; |
| interrupt-parent = <&gpio>; |
| interrupts = <TEGRA_GPIO(W, 3) GPIO_ACTIVE_HIGH>; |
| realtek,ldo1-en-gpios = |
| <&gpio TEGRA_GPIO(V, 3) GPIO_ACTIVE_HIGH>; |
| }; |
