| // SPDX-License-Identifier: GPL-2.0 | |
| /* | |
| * Detect hard lockups on a system | |
| * | |
| * started by Don Zickus, Copyright (C) 2010 Red Hat, Inc. | |
| * | |
| * Note: Most of this code is borrowed heavily from the original softlockup | |
| * detector, so thanks to Ingo for the initial implementation. | |
| * Some chunks also taken from the old x86-specific nmi watchdog code, thanks | |
| * to those contributors as well. | |
| */ | |
| #define pr_fmt(fmt) "NMI watchdog: " fmt | |
| #include <linux/nmi.h> | |
| #include <linux/atomic.h> | |
| #include <linux/module.h> | |
| #include <linux/sched/debug.h> | |
| #include <asm/irq_regs.h> | |
| #include <linux/perf_event.h> | |
| static DEFINE_PER_CPU(bool, hard_watchdog_warn); | |
| static DEFINE_PER_CPU(bool, watchdog_nmi_touch); | |
| static DEFINE_PER_CPU(struct perf_event *, watchdog_ev); | |
| static DEFINE_PER_CPU(struct perf_event *, dead_event); | |
| static struct cpumask dead_events_mask; | |
| static unsigned long hardlockup_allcpu_dumped; | |
| static atomic_t watchdog_cpus = ATOMIC_INIT(0); | |
| notrace void arch_touch_nmi_watchdog(void) | |
| { | |
| /* | |
| * Using __raw here because some code paths have | |
| * preemption enabled. If preemption is enabled | |
| * then interrupts should be enabled too, in which | |
| * case we shouldn't have to worry about the watchdog | |
| * going off. | |
| */ | |
| raw_cpu_write(watchdog_nmi_touch, true); | |
| } | |
| EXPORT_SYMBOL(arch_touch_nmi_watchdog); | |
| #ifdef CONFIG_HARDLOCKUP_CHECK_TIMESTAMP | |
| static DEFINE_PER_CPU(ktime_t, last_timestamp); | |
| static DEFINE_PER_CPU(unsigned int, nmi_rearmed); | |
| static ktime_t watchdog_hrtimer_sample_threshold __read_mostly; | |
| void watchdog_update_hrtimer_threshold(u64 period) | |
| { | |
| /* | |
| * The hrtimer runs with a period of (watchdog_threshold * 2) / 5 | |
| * | |
| * So it runs effectively with 2.5 times the rate of the NMI | |
| * watchdog. That means the hrtimer should fire 2-3 times before | |
| * the NMI watchdog expires. The NMI watchdog on x86 is based on | |
| * unhalted CPU cycles, so if Turbo-Mode is enabled the CPU cycles | |
| * might run way faster than expected and the NMI fires in a | |
| * smaller period than the one deduced from the nominal CPU | |
| * frequency. Depending on the Turbo-Mode factor this might be fast | |
| * enough to get the NMI period smaller than the hrtimer watchdog | |
| * period and trigger false positives. | |
| * | |
| * The sample threshold is used to check in the NMI handler whether | |
| * the minimum time between two NMI samples has elapsed. That | |
| * prevents false positives. | |
| * | |
| * Set this to 4/5 of the actual watchdog threshold period so the | |
| * hrtimer is guaranteed to fire at least once within the real | |
| * watchdog threshold. | |
| */ | |
| watchdog_hrtimer_sample_threshold = period * 2; | |
| } | |
| static bool watchdog_check_timestamp(void) | |
| { | |
| ktime_t delta, now = ktime_get_mono_fast_ns(); | |
| delta = now - __this_cpu_read(last_timestamp); | |
| if (delta < watchdog_hrtimer_sample_threshold) { | |
| /* | |
| * If ktime is jiffies based, a stalled timer would prevent | |
| * jiffies from being incremented and the filter would look | |
| * at a stale timestamp and never trigger. | |
| */ | |
| if (__this_cpu_inc_return(nmi_rearmed) < 10) | |
| return false; | |
| } | |
| __this_cpu_write(nmi_rearmed, 0); | |
| __this_cpu_write(last_timestamp, now); | |
| return true; | |
| } | |
| #else | |
| static inline bool watchdog_check_timestamp(void) | |
| { | |
| return true; | |
| } | |
| #endif | |
| static struct perf_event_attr wd_hw_attr = { | |
| .type = PERF_TYPE_HARDWARE, | |
| .config = PERF_COUNT_HW_CPU_CYCLES, | |
| .size = sizeof(struct perf_event_attr), | |
| .pinned = 1, | |
| .disabled = 1, | |
| }; | |
| /* Callback function for perf event subsystem */ | |
| static void watchdog_overflow_callback(struct perf_event *event, | |
| struct perf_sample_data *data, | |
| struct pt_regs *regs) | |
| { | |
| /* Ensure the watchdog never gets throttled */ | |
| event->hw.interrupts = 0; | |
| if (__this_cpu_read(watchdog_nmi_touch) == true) { | |
| __this_cpu_write(watchdog_nmi_touch, false); | |
| return; | |
| } | |
| if (!watchdog_check_timestamp()) | |
| return; | |
| /* check for a hardlockup | |
| * This is done by making sure our timer interrupt | |
| * is incrementing. The timer interrupt should have | |
| * fired multiple times before we overflow'd. If it hasn't | |
| * then this is a good indication the cpu is stuck | |
| */ | |
| if (is_hardlockup()) { | |
| int this_cpu = smp_processor_id(); | |
| /* only print hardlockups once */ | |
| if (__this_cpu_read(hard_watchdog_warn) == true) | |
| return; | |
| pr_emerg("Watchdog detected hard LOCKUP on cpu %d", this_cpu); | |
| print_modules(); | |
| print_irqtrace_events(current); | |
| if (regs) | |
| show_regs(regs); | |
| else | |
| dump_stack(); | |
| /* | |
| * Perform all-CPU dump only once to avoid multiple hardlockups | |
| * generating interleaving traces | |
| */ | |
| if (sysctl_hardlockup_all_cpu_backtrace && | |
| !test_and_set_bit(0, &hardlockup_allcpu_dumped)) | |
| trigger_allbutself_cpu_backtrace(); | |
| if (hardlockup_panic) | |
| nmi_panic(regs, "Hard LOCKUP"); | |
| __this_cpu_write(hard_watchdog_warn, true); | |
| return; | |
| } | |
| __this_cpu_write(hard_watchdog_warn, false); | |
| return; | |
| } | |
| static int hardlockup_detector_event_create(void) | |
| { | |
| unsigned int cpu = smp_processor_id(); | |
| struct perf_event_attr *wd_attr; | |
| struct perf_event *evt; | |
| wd_attr = &wd_hw_attr; | |
| wd_attr->sample_period = hw_nmi_get_sample_period(watchdog_thresh); | |
| /* Try to register using hardware perf events */ | |
| evt = perf_event_create_kernel_counter(wd_attr, cpu, NULL, | |
| watchdog_overflow_callback, NULL); | |
| if (IS_ERR(evt)) { | |
| pr_info("Perf event create on CPU %d failed with %ld\n", cpu, | |
| PTR_ERR(evt)); | |
| return PTR_ERR(evt); | |
| } | |
| this_cpu_write(watchdog_ev, evt); | |
| return 0; | |
| } | |
| /** | |
| * hardlockup_detector_perf_enable - Enable the local event | |
| */ | |
| void hardlockup_detector_perf_enable(void) | |
| { | |
| if (hardlockup_detector_event_create()) | |
| return; | |
| /* use original value for check */ | |
| if (!atomic_fetch_inc(&watchdog_cpus)) | |
| pr_info("Enabled. Permanently consumes one hw-PMU counter.\n"); | |
| perf_event_enable(this_cpu_read(watchdog_ev)); | |
| } | |
| /** | |
| * hardlockup_detector_perf_disable - Disable the local event | |
| */ | |
| void hardlockup_detector_perf_disable(void) | |
| { | |
| struct perf_event *event = this_cpu_read(watchdog_ev); | |
| if (event) { | |
| perf_event_disable(event); | |
| this_cpu_write(watchdog_ev, NULL); | |
| this_cpu_write(dead_event, event); | |
| cpumask_set_cpu(smp_processor_id(), &dead_events_mask); | |
| atomic_dec(&watchdog_cpus); | |
| } | |
| } | |
| /** | |
| * hardlockup_detector_perf_cleanup - Cleanup disabled events and destroy them | |
| * | |
| * Called from lockup_detector_cleanup(). Serialized by the caller. | |
| */ | |
| void hardlockup_detector_perf_cleanup(void) | |
| { | |
| int cpu; | |
| for_each_cpu(cpu, &dead_events_mask) { | |
| struct perf_event *event = per_cpu(dead_event, cpu); | |
| /* | |
| * Required because for_each_cpu() reports unconditionally | |
| * CPU0 as set on UP kernels. Sigh. | |
| */ | |
| if (event) | |
| perf_event_release_kernel(event); | |
| per_cpu(dead_event, cpu) = NULL; | |
| } | |
| cpumask_clear(&dead_events_mask); | |
| } | |
| /** | |
| * hardlockup_detector_perf_stop - Globally stop watchdog events | |
| * | |
| * Special interface for x86 to handle the perf HT bug. | |
| */ | |
| void __init hardlockup_detector_perf_stop(void) | |
| { | |
| int cpu; | |
| lockdep_assert_cpus_held(); | |
| for_each_online_cpu(cpu) { | |
| struct perf_event *event = per_cpu(watchdog_ev, cpu); | |
| if (event) | |
| perf_event_disable(event); | |
| } | |
| } | |
| /** | |
| * hardlockup_detector_perf_restart - Globally restart watchdog events | |
| * | |
| * Special interface for x86 to handle the perf HT bug. | |
| */ | |
| void __init hardlockup_detector_perf_restart(void) | |
| { | |
| int cpu; | |
| lockdep_assert_cpus_held(); | |
| if (!(watchdog_enabled & NMI_WATCHDOG_ENABLED)) | |
| return; | |
| for_each_online_cpu(cpu) { | |
| struct perf_event *event = per_cpu(watchdog_ev, cpu); | |
| if (event) | |
| perf_event_enable(event); | |
| } | |
| } | |
| /** | |
| * hardlockup_detector_perf_init - Probe whether NMI event is available at all | |
| */ | |
| int __init hardlockup_detector_perf_init(void) | |
| { | |
| int ret = hardlockup_detector_event_create(); | |
| if (ret) { | |
| pr_info("Perf NMI watchdog permanently disabled\n"); | |
| } else { | |
| perf_event_release_kernel(this_cpu_read(watchdog_ev)); | |
| this_cpu_write(watchdog_ev, NULL); | |
| } | |
| return ret; | |
| } |