blob: 4419631604b4fdb507b212feab608a1a1f69d850 [file] [log] [blame]
/* SPDX-License-Identifier: GPL-2.0 OR BSD-3-Clause */
/*
* Copyright (C) 2012-2014, 2018-2019, 2023 Intel Corporation
* Copyright (C) 2013-2015 Intel Mobile Communications GmbH
* Copyright (C) 2016-2017 Intel Deutschland GmbH
*/
#ifndef __iwl_fw_api_config_h__
#define __iwl_fw_api_config_h__
/*
* struct iwl_dqa_enable_cmd
* @cmd_queue: the TXQ number of the command queue
*/
struct iwl_dqa_enable_cmd {
__le32 cmd_queue;
} __packed; /* DQA_CONTROL_CMD_API_S_VER_1 */
/*
* struct iwl_tx_ant_cfg_cmd
* @valid: valid antenna configuration
*/
struct iwl_tx_ant_cfg_cmd {
__le32 valid;
} __packed;
/**
* struct iwl_calib_ctrl - Calibration control struct.
* Sent as part of the phy configuration command.
* @flow_trigger: bitmap for which calibrations to perform according to
* flow triggers, using &enum iwl_calib_cfg
* @event_trigger: bitmap for which calibrations to perform according to
* event triggers, using &enum iwl_calib_cfg
*/
struct iwl_calib_ctrl {
__le32 flow_trigger;
__le32 event_trigger;
} __packed;
/* This enum defines the bitmap of various calibrations to enable in both
* init ucode and runtime ucode through CALIBRATION_CFG_CMD.
*/
enum iwl_calib_cfg {
IWL_CALIB_CFG_XTAL_IDX = BIT(0),
IWL_CALIB_CFG_TEMPERATURE_IDX = BIT(1),
IWL_CALIB_CFG_VOLTAGE_READ_IDX = BIT(2),
IWL_CALIB_CFG_PAPD_IDX = BIT(3),
IWL_CALIB_CFG_TX_PWR_IDX = BIT(4),
IWL_CALIB_CFG_DC_IDX = BIT(5),
IWL_CALIB_CFG_BB_FILTER_IDX = BIT(6),
IWL_CALIB_CFG_LO_LEAKAGE_IDX = BIT(7),
IWL_CALIB_CFG_TX_IQ_IDX = BIT(8),
IWL_CALIB_CFG_TX_IQ_SKEW_IDX = BIT(9),
IWL_CALIB_CFG_RX_IQ_IDX = BIT(10),
IWL_CALIB_CFG_RX_IQ_SKEW_IDX = BIT(11),
IWL_CALIB_CFG_SENSITIVITY_IDX = BIT(12),
IWL_CALIB_CFG_CHAIN_NOISE_IDX = BIT(13),
IWL_CALIB_CFG_DISCONNECTED_ANT_IDX = BIT(14),
IWL_CALIB_CFG_ANT_COUPLING_IDX = BIT(15),
IWL_CALIB_CFG_DAC_IDX = BIT(16),
IWL_CALIB_CFG_ABS_IDX = BIT(17),
IWL_CALIB_CFG_AGC_IDX = BIT(18),
};
/**
* struct iwl_phy_specific_cfg - specific PHY filter configuration
*
* Sent as part of the phy configuration command (v3) to configure specific FW
* defined PHY filters that can be applied to each antenna.
*
* @filter_cfg_chains: filter config id for LMAC1 chain A, LMAC1 chain B,
* LMAC2 chain A, LMAC2 chain B (in that order)
* values: 0: no filter; 0xffffffff: reserved; otherwise: filter id
*/
struct iwl_phy_specific_cfg {
__le32 filter_cfg_chains[4];
} __packed; /* PHY_SPECIFIC_CONFIGURATION_API_VER_1*/
/**
* struct iwl_phy_cfg_cmd - Phy configuration command
*
* @phy_cfg: PHY configuration value, uses &enum iwl_fw_phy_cfg
* @calib_control: calibration control data
*/
struct iwl_phy_cfg_cmd_v1 {
__le32 phy_cfg;
struct iwl_calib_ctrl calib_control;
} __packed;
/**
* struct iwl_phy_cfg_cmd_v3 - Phy configuration command (v3)
*
* @phy_cfg: PHY configuration value, uses &enum iwl_fw_phy_cfg
* @calib_control: calibration control data
* @phy_specific_cfg: configure predefined PHY filters
*/
struct iwl_phy_cfg_cmd_v3 {
__le32 phy_cfg;
struct iwl_calib_ctrl calib_control;
struct iwl_phy_specific_cfg phy_specific_cfg;
} __packed; /* PHY_CONFIGURATION_CMD_API_S_VER_3 */
/*
* enum iwl_dc2dc_config_id - flag ids
*
* Ids of dc2dc configuration flags
*/
enum iwl_dc2dc_config_id {
DCDC_LOW_POWER_MODE_MSK_SET = 0x1, /* not used */
DCDC_FREQ_TUNE_SET = 0x2,
}; /* MARKER_ID_API_E_VER_1 */
#endif /* __iwl_fw_api_config_h__ */