| /* SPDX-License-Identifier: GPL-2.0 */ | |
| #ifndef FWH_LOCK_H | |
| #define FWH_LOCK_H | |
| enum fwh_lock_state { | |
| FWH_UNLOCKED = 0, | |
| FWH_DENY_WRITE = 1, | |
| FWH_IMMUTABLE = 2, | |
| FWH_DENY_READ = 4, | |
| }; | |
| struct fwh_xxlock_thunk { | |
| enum fwh_lock_state val; | |
| flstate_t state; | |
| }; | |
| #define FWH_XXLOCK_ONEBLOCK_LOCK ((struct fwh_xxlock_thunk){ FWH_DENY_WRITE, FL_LOCKING}) | |
| #define FWH_XXLOCK_ONEBLOCK_UNLOCK ((struct fwh_xxlock_thunk){ FWH_UNLOCKED, FL_UNLOCKING}) | |
| /* | |
| * This locking/unlock is specific to firmware hub parts. Only one | |
| * is known that supports the Intel command set. Firmware | |
| * hub parts cannot be interleaved as they are on the LPC bus | |
| * so this code has not been tested with interleaved chips, | |
| * and will likely fail in that context. | |
| */ | |
| static int fwh_xxlock_oneblock(struct map_info *map, struct flchip *chip, | |
| unsigned long adr, int len, void *thunk) | |
| { | |
| struct cfi_private *cfi = map->fldrv_priv; | |
| struct fwh_xxlock_thunk *xxlt = (struct fwh_xxlock_thunk *)thunk; | |
| int ret; | |
| /* Refuse the operation if the we cannot look behind the chip */ | |
| if (chip->start < 0x400000) { | |
| pr_debug( "MTD %s(): chip->start: %lx wanted >= 0x400000\n", | |
| __func__, chip->start ); | |
| return -EIO; | |
| } | |
| /* | |
| * lock block registers: | |
| * - on 64k boundariesand | |
| * - bit 1 set high | |
| * - block lock registers are 4MiB lower - overflow subtract (danger) | |
| * | |
| * The address manipulation is first done on the logical address | |
| * which is 0 at the start of the chip, and then the offset of | |
| * the individual chip is addted to it. Any other order a weird | |
| * map offset could cause problems. | |
| */ | |
| adr = (adr & ~0xffffUL) | 0x2; | |
| adr += chip->start - 0x400000; | |
| /* | |
| * This is easy because these are writes to registers and not writes | |
| * to flash memory - that means that we don't have to check status | |
| * and timeout. | |
| */ | |
| mutex_lock(&chip->mutex); | |
| ret = get_chip(map, chip, adr, FL_LOCKING); | |
| if (ret) { | |
| mutex_unlock(&chip->mutex); | |
| return ret; | |
| } | |
| chip->oldstate = chip->state; | |
| chip->state = xxlt->state; | |
| map_write(map, CMD(xxlt->val), adr); | |
| /* Done and happy. */ | |
| chip->state = chip->oldstate; | |
| put_chip(map, chip, adr); | |
| mutex_unlock(&chip->mutex); | |
| return 0; | |
| } | |
| static int fwh_lock_varsize(struct mtd_info *mtd, loff_t ofs, uint64_t len) | |
| { | |
| int ret; | |
| ret = cfi_varsize_frob(mtd, fwh_xxlock_oneblock, ofs, len, | |
| (void *)&FWH_XXLOCK_ONEBLOCK_LOCK); | |
| return ret; | |
| } | |
| static int fwh_unlock_varsize(struct mtd_info *mtd, loff_t ofs, uint64_t len) | |
| { | |
| int ret; | |
| ret = cfi_varsize_frob(mtd, fwh_xxlock_oneblock, ofs, len, | |
| (void *)&FWH_XXLOCK_ONEBLOCK_UNLOCK); | |
| return ret; | |
| } | |
| static void fixup_use_fwh_lock(struct mtd_info *mtd) | |
| { | |
| printk(KERN_NOTICE "using fwh lock/unlock method\n"); | |
| /* Setup for the chips with the fwh lock method */ | |
| mtd->_lock = fwh_lock_varsize; | |
| mtd->_unlock = fwh_unlock_varsize; | |
| } | |
| #endif /* FWH_LOCK_H */ |