# SPDX-License-Identifier: (GPL-2.0-only or BSD-2-Clause)
%YAML 1.2
---
$id: http://devicetree.org/schemas/power/reset/gpio-poweroff.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#

title: GPIO controlled power off

maintainers:
  - Sebastian Reichel <sre@kernel.org>

description: >
  System power off support via a GPIO line. When a shutdown is
  executed the operating system is expected to switch the GPIO
  from inactive to active. After a delay (active-delay-ms) it
  is expected to be switched back to inactive. After another
  delay (inactive-delay-ms) it is configured as active again.
  Finally the operating system assumes the power off failed if
  the system is still running after waiting some time (timeout-ms).

properties:
  compatible:
    const: gpio-poweroff

  gpios:
    maxItems: 1

  input:
    type: boolean
    description: >
      Initially configure the GPIO line as an input. Only reconfigure
      it to an output when the power-off sequence is initiated. If this optional
      property is not specified, the GPIO is initialized as an output in its inactive state.

  active-delay-ms:
    default: 100
    description: Delay to wait after driving gpio active

  inactive-delay-ms:
    default: 100
    description: Delay to wait after driving gpio inactive

  timeout-ms:
    default: 3000
    description: Time to wait before assuming the power off sequence failed.

required:
  - compatible
  - gpios

additionalProperties: false

examples:
  - |
    gpio-poweroff {
        compatible = "gpio-poweroff";
        gpios = <&gpio 4 0>;
        timeout-ms = <3000>;
    };