blob: ee459806d35e3256e9a36d820f6cf3758c89543b [file] [log] [blame] [edit]
PPC4xx Clock Power Management (CPM) node
Required properties:
- compatible : compatible list, currently only "ibm,cpm"
- dcr-access-method : "native"
- dcr-reg : < DCR register range >
Optional properties:
- er-offset : All 4xx SoCs with a CPM controller have
one of two different order for the CPM
registers. Some have the CPM registers
in the following order (ER,FR,SR). The
others have them in the following order
(SR,ER,FR). For the second case set
er-offset = <1>.
- unused-units : specifier consist of one cell. For each
bit in the cell, the corresponding bit
in CPM will be set to turn off unused
devices.
- idle-doze : specifier consist of one cell. For each
bit in the cell, the corresponding bit
in CPM will be set to turn off unused
devices. This is usually just CPM[CPU].
- standby : specifier consist of one cell. For each
bit in the cell, the corresponding bit
in CPM will be set on standby and
restored on resume.
- suspend : specifier consist of one cell. For each
bit in the cell, the corresponding bit
in CPM will be set on suspend (mem) and
restored on resume. Note, for standby
and suspend the corresponding bits can
be different or the same. Usually for
standby only class 2 and 3 units are set.
However, the interface does not care.
If they are the same, the additional
power saving will be seeing if support
is available to put the DDR in self
refresh mode and any additional power
saving techniques for the specific SoC.
Example:
CPM0: cpm {
compatible = "ibm,cpm";
dcr-access-method = "native";
dcr-reg = <0x160 0x003>;
er-offset = <0>;
unused-units = <0x00000100>;
idle-doze = <0x02000000>;
standby = <0xfeff0000>;
suspend = <0xfeff791d>;
};