[PATCH] pcmcia: use bitfield instead of p_state and state
Instead of the two status values struct pcmcia_device->p_state and state,
use descriptive bitfields. Most value-checking in drivers was invalid, as
the core now only calls the ->remove() (a.k.a. detach) function in case the
attachement _and_ configuration was successful.
Signed-off-by: Dominik Brodowski <linux@dominikbrodowski.net>
diff --git a/drivers/bluetooth/bluecard_cs.c b/drivers/bluetooth/bluecard_cs.c
index 50174fb..473a13b 100644
--- a/drivers/bluetooth/bluecard_cs.c
+++ b/drivers/bluetooth/bluecard_cs.c
@@ -244,7 +244,7 @@
clear_bit(XMIT_WAKEUP, &(info->tx_state));
- if (!(info->p_dev->state & DEV_PRESENT))
+ if (!pcmcia_dev_present(info->p_dev))
return;
if (test_bit(XMIT_BUFFER_NUMBER, &(info->tx_state))) {
@@ -879,7 +879,6 @@
link->conf.Attributes = CONF_ENABLE_IRQ;
link->conf.IntType = INT_MEMORY_AND_IO;
- link->state |= DEV_PRESENT | DEV_CONFIG_PENDING;
return bluecard_config(link);
}
@@ -888,9 +887,7 @@
{
bluecard_info_t *info = link->priv;
- if (link->state & DEV_CONFIG)
- bluecard_release(link);
-
+ bluecard_release(link);
kfree(info);
}
@@ -933,9 +930,6 @@
link->conf.ConfigBase = parse.config.base;
link->conf.Present = parse.config.rmask[0];
- /* Configure card */
- link->state |= DEV_CONFIG;
-
link->conf.ConfigIndex = 0x20;
link->io.NumPorts1 = 64;
link->io.IOAddrLines = 6;
@@ -969,7 +963,6 @@
strcpy(info->node.dev_name, info->hdev->name);
link->dev_node = &info->node;
- link->state &= ~DEV_CONFIG_PENDING;
return 0;
@@ -986,8 +979,7 @@
{
bluecard_info_t *info = link->priv;
- if (link->state & DEV_PRESENT)
- bluecard_close(info);
+ bluecard_close(info);
del_timer(&(info->timer));
